Mitsubishi Electric Mr.SLIM PLA Series Service Manual page 45

OPERATING PROCEDURE
10. Removing the drain pump (DP) and float switch (FS)
(1) Remove the drain pan. (See Photo 6)
(2) Cut the hose band and remove the hose.
(3) Remove the drain pump assembly (3 screws and 2 hooks).
(4) Remove the drain pump (3 screws).
(5) Remove the float switch (2 screws).
11. Removing the heat exchanger
(1) Remove the drain pan. (See Photo 6)
(2) Remove the 3 screws of the piping cover, and pull out
piping cover.
(3) Remove the 2 screws of coil plate.
(4) Remove the 2 screws of the coil.
(5) Remove the screw of the coil support.
(6) Pull out the heat exchanger.
OCH529
PHOTOS & ILLUSTRATIONS
Photo 7
Float switch
Hose band
Drain pump
Photo 8
Drain pump fixing screw
Photo 9
Piping cover
Coil plate
Heat exchanger
fixing screw
45
Drain pump
assembly fixing screw
Float switch fixing screw
Heat exchanger
Coil support
Coil support fixing screw