Advertisement
Available languages
Available languages
EN
7. Push the rubber hose onto the hose joint as far as it will go. Do not
use a vinyl plastic hose, as this can be dangerous. Secure the hose with
both sides of hose clamp.(Fig.13) see to it that the rubber hose does not
touch a part of the gas cooker nor lies underneath it.
Over 100 cm
Over
15 cm
How to use the device
1. To light the burners:
a. Open the main gas valve. Push the gas control knob in and turn it towards the MAX position (counter-clockwise) until you
hear the click. Make sure that the burner has been lit (Fig.15) in this position, double burner will light up both the small and
large burners. To use only the small burner, release the gas control knob and turn it further to the MIN position. (Fig. 16)
b. To adjust the flame size.
Set the gas control knob to a suitable position between MAX (full flame size) and MIN position (small flame size).
6
4. Attach the rubber legs to the cooker by turning the cooker upside down
5. Install the burners.
6. Place the trivets on top of the burner. The trivets can be adjusted by
Fig. 12
Ceiling
Wall
Over 15 cm
Wall
Over
15 cm
Wall
Fig. 14
WWW.NIKOLAOUTOOLS.GR
and screwing them into the openings on the cooker bottom.(Fig. 12)
turning the screws and then the pan can be put on the trivets steadily.
Hose joint
8. When choosing a place to put the gas cooker,be sure to pick a spot
that is firm and level. The gas cooker need plenty of space and air.
Allow at least 15cm of space on the sides and 100cm above the unit.
(Fig.14) if the space is less than 15cm from the in-flammable walls, be
sure to provide a heat insulation board. Also be sure to keep paper, oil,
and all other inflammable objects away from the gas cooker.
Turn
Fig. 15
Air damper for burner
Fig. 17
Rubber hose
Push
Fig. 16
Minimum
Maximum
Fig. 18
Fig. 13
Fig. 16
Advertisement
