Sears KENMORE ELITE 630.13952 Manual page 40

Fault Diagnostics
Error code displays
Error codes can be found using the customer service test program.
1. Open the door.
2. While pushing (and holding) any two wash cycle buttons, turn the
dishwasher on with the on/off switch. While the buttons are held, the
model coding will show (e.g. "C2", "C5", etc.).
buttons, LED "B" will be lit and LED "C" will flash and "P0" will display,
confirming you're in the special programs menu.
3. Push button "C" to start the Error Code program (instead of pushing "B"
to select the test program). As button "C" is held, the earliest cycle with
an error code is displayed ("00") – when button "C" is released, the error
code is displayed. If there's more than one error code, the code with the
highest priority is displayed (see chart below).
4. The last 8 error codes are stored. Repeatedly pushing and releasing
button "C" scrolls from the oldest cycle with an error code ("00") to the
latest ("07").
Dishwashers can show the following error codes.
Error code E5 is safety float water level reached. If this error code occurs,
check the float and float switch, check if water is in the base and check if the
water inlet valve has re-seated after closing.
Clearing error codes
To clear error codes, run the customer service test program.
702_58300000149896_ara_en_b
All manuals and user guides at all-guides.com
After releasing the