DonLim Hoper layer EP1216-SA User Manual

Clothes dryer

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

EP1216-SA

Clothes Dryer User Manual

干衣机操作说明书

Table of Contents

Need help?

Do you have a question about the Hoper layer EP1216-SA and is the answer not in the manual?

Questions and answers

Summary of Contents for DonLim Hoper layer EP1216-SA

Page 1 EP1216-SA Clothes Dryer User Manual 干衣机操作说明书...
Page 2 EP1216-SA...
Page 3 重要安全须知...
Page 4 警告：请妥善保管此说明书。...
Page 5 认识产品...
Page 6 TIME SET EP1216-SA 220V-240V 50Hz 800W 产品特点 3.30 -180...
Page 7 预先操作说明...
Page 9 7.套入布罩，注意布罩需套入底部扣位。（如图5）图5 8.盖上顶盖。（如图）图...
Page 10 请务必进行以上预先操作后再使用干衣机。使用说明 ON/OFF TIME SET...
Page 11 “ 30-60-90-120-150- 180- ON/OFF TIME SET 备注： ON/OFF TIME SET...
Page 12 4.工作状态：干衣机工作时候，数字显示也会随时间减少，工作完成后，会发出三声蜂鸣声，显示屏闪烁。此时，干衣机内的风机会继续转动约1分钟来散热，然后干衣机自动关机。（如图11） ON/OFF TIME SET 图11 收纳说明请断电后待产品冷却再进行收纳处理。 1.将顶盖、布罩、支架、伸缩杆、脚垫依次拆卸。如图12 图12...
Page 16 清洁保养请断电后待产品冷却再进行清洁保养...
Page 19 +61 03 7016 7996 or +61 406 198 737 Support@hoperlayer.com.au FRANK AND ANDY TRADING PTY LTD 公司地址： Unit 1/30 Edwards Street，Burwood VIC 3125...
Page 20: Table Of Contents
TABLE OF CONTENTS Clothes Dryer EP1216-SA Important Safety Instructions Know Your Product Product Features Pre-operation Instructions Instructions for Use Cleaning and Maintenance References for Drying Time Composition and Content of Toxic and Harmful Substances Warranty Policy of Repair, Replacement and Refund for Electrical Products Warranty Card...
Page 21: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Before using this product, please read this manual carefully and follow the notes below: Please check that the voltage marked on the bottom of the product is in line with the service voltage. Unplug the Dryer after use. Do not insert anything into the product.
Page 22 Neither immerse the equipment or power cord in water, nor let anything damp get near them. Disassemble without authorization is not allowed. In case of failure, please send it to the local after-sales for maintenance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Page 23: Know Your Product
KNOW YOUR PRODUCT The Company reserves the right to change the design of the product. The product you purchased may have been improved without further notice and is not completely consistent with the manual, in kind prevail. However, it will not change its performance and usage, so rest assured to use.
Page 24: Product Features
Control Panel TIME SET ON/OFF Button Display Timing Button Product Information Product Name Clothes Dryer EP1216-SA Model 220V-240V 50Hz Power 800W Rated Power PRODUCT FEATURES Easy to be stored and carried for its storage box structure. Controlled by two touch buttons only. Six-interval timing function ranging from 30 mins to 180 mins and a long time power on.
Page 25: Pre-Operation Instructions
PRE-OPERATION INSTRUCTIONS Unpack and take out the product carefully. Select a hard and flat horizontal surface, which shall not hinder the air inlet or outlet. Press the Top Cover Buckle on both sides of the Top Cover to disconnect the Top Cover, and then take out the Cloth Cover, Support, Telescopic Rod and Stand in the box.
Page 26 5. Pull the Telescopic Rods apart and insert them into the round holes at the four corners of the box. (Figure 3) (Figure 3) 6. Slide the Support onto the four Telescopic Rods. (Figure 4) (Figure 4)
Page 27 7. Slide in the Cloth Cover. Note that the Cloth Cover needs to be slide into the bottom buckle(Figure 5) (Figure 5) 8. Close the Top Cover. (Figure 6) (Figure 6)
Page 28: Instructions For Use
9. Hang the clothes to be dried on the Support. (Figure (Figure 7) Please be sure to carry out the above pre-operation before using the clothes dryer. INSTRUCTIONS FOR USE 1. Power on to standby mode and the display flashes. (Figure 8) ON/OFF TIME SET...
Page 29 2. Adjust the drying time according to the references by touching the Timing Button. Each touch will increase the time by 30 minutes. When "ON" is displayed, it means a long-time power on. (30-60-90-120-150- 180-ON) (Figure 9) ON/OFF TIME SET (Figure 9) 3.
Page 30 4. Working status: when the clothes dryer is working, the displayed number will decrease with time. After the work is completed, three beeps will sound and the display will flash. At this time, the fan in the clothes dryer will continue to rotate for about 1 minute to dissipate heat, and then the clothes dryer will automatically shut down.
Page 31 2. Retract the power cord and install it onto the buckle. (Figure 13) (Figure 13) 3. Place the Stands inside the box as shown in the figure. (Figure 14) (Figure 14)
Page 32 4. Retract the Telescopic Rods, lock the buckles, and place them inside the box as shown in the figure. Pay attention to the direction of the buckles. (Figure 15) (Figure 15) 5. Stack the Cloth Cover neatly and place it inside as shown in the figure.
Page 33 6. Fasten the Support as shown in the figure. (Figure (Figure 17) 7. Check and make sure all the accessories have been placed inside, and then fasten the Top Cover. (Figure 18) (Figure 18)
Page 34: Cleaning And Maintenance
CLEANING AND MAINTENANCE Please cut off the power and wait for the product to cool off before cleaning and maintenance. Normally, disconnect the power before cleaning. Neither immerse the equipment in water, nor let anything damp get near them. To keep it dust-free, please wrap the product and put it back in the package if the product is to be spared for a long time.
Page 35: Composition And Content Of Toxic And Harmful Substances
COMPOSITION AND CONTENT OF TOXIC AND HARMFUL SUBSTANCES In order to be in line with the Administrative Measures the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Products, the names of electri- cal product parts and the information of harmful substanc- es that may be contained are provided as follows.
Page 36: Warranty Policy Of Repair, Replacement And Refund For Electrical Products
be marked with the label of Environment Friendly Use Period (EFUP). The label of EFUP indicates the use period under normal service conditions, temperature and humidity, excluding consumables such as batteries. WARRANTY POLICY OF REPAIR, REPLACEMENT AND REFUND FOR ELECTRICAL PRODUCTS To ensure our consumers have the best after-sales service, the Company implements warranty services of repair, replacement and refund evidenced by this...
Page 37: Warranty Card
Distinguished User: Greetings! Thank you for your trust and support of our products. The warranty card is attached to each product. Please keep it in a safe place. Complete the following detailed information in case of warranty. The warranty card is issued once only. WARRANTY CARD User Name: Tel:...
Page 38 FRANK AND ANDY TRADING PTY LTD www.hoperlayer.com.au Unit 1/30 Edwards Street，Burwood VIC 3125 EESS-E8151 +61 03 7016 7996 +61 406 198 737 Support@hoperlayer.com.au Qualified Certificate The product has been inspected according to the standards and is approved for delivery. Inspected by: Ex-factory Date: WWW.DONLIM.COM...