Toyotomi zibro LC-30T Operating Manual page 16

1 Only install a new Toyotube bottle, when
the heater has been shut off and cooled
down, by pressing the ON/OFF button on
an electronic heater and the red button on
a wick type heater.
2 Open the tank lid and remove the standard
"removable metal fuel tank" from the
heater .
3 Remove the standard "fuel acceptance fitting" and replace it with the special "dedicated" red colored
Toyotube fuel adapter.
4 Place the Toyotube fuel adapter into the fix fuel reservoir of the heater, when it is installed, press it
strongly so it fits tightly in the fuel reservoir of the heater.
The Toyotube fuel adapter has a small tab, this part should be positioned at the front side of the heater
when it is installed. Check the position of the fuel adapter as indicated by the arrow.
The heater is now ready to use the Toyotube bottle.
(Note: when you install the dedicated Toyotube fuel adapter in the fixed reservoir of the heater in the
right way, the connection should be very solid. When it is absolutely necessary to remove the fuel
adapter again, this may cause damage to the adapter. Do NOT us a fuel adapter which shows damages,
it can't be strongly connected again to the reservoir of the heater, which can cause product failure).
4
14