Panasonic KX-TC2000SNB Service Manual page 65

29. FOR SCHEMATIC DIAGRAM
29.1. Base Unit
1. DC voltage measurements are taken with an oscilloscope or a
tester with a ground.
2. The schematic diagrams and circuit board may be modified at any
time with the development of new technology.
Important Safety Notice:
Components identified by
for safety. When replacing any of these components, use only the
manufacturer´s specified parts.
29.2. Handset (SCHEMATIC DIAGRAM
1. DC voltage measurements are taken with an oscilloscope or a
tester with a ground.
2. The schematic diagrams and circuit board may be modified at any
time with the development of new technology.
30. SCHEMATIC DIAGRAM (Base Unit)
30.1. Base Unit
30.2. RF Unit (Base Unit)
31. SCHEMATIC DIAGRAM (Handset)
31.1. Handset
31.2. RF Unit (Handset)
31.3. Memo
32. CIRCUIT BOARD (Base Unit)
32.1. Component View
32.2. Flow Solder Side View
33. CIRCUIT BOARD (Handset)
33.1. Component View
(SCHEMATIC DIAGRAM (Base
mark have special characteristics important
Unit))
(Handset))
65