Windmere Clothes Shaver Plus - Professional-Size Fabric Pill Remover Manual

OPERATING INSTRUCTIONS

PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS

USE AND CARE

1. The Clothes Shaver Plus^® fabric pill remover is better suited for use on some fabrics than others. Do not use this device on very soft fabrics or materials textured by design. Prior to use, always test the Clothes Shaver Plus^® fabric pill remover on a hidden, inconspicuous area of the garment to be shaved.
2. Remove the protective cap and slide the On/Off switch to the"On" position. Glide the head of the unit lightly over the garment to remove fuzz, pills (nubby fabric clusters caused by friction) and pulled threads.
3. After each use, or when the storage bin is about half full, emptyit. To remove, press firmly on the sides and slide the bin down. After emptying, replace the storage bin by sliding it up on the unit. When the bin "clicks," it is positioned properly. This procedure will ensure best cutting performance.
4. Keep the protective cap on the unit when not in use.

NOTE:
It is recommended for best performance of this product to add a thin coating of light oil or silicone spray to the inner surface of the foil. Apply the oil/spray to a lint-free cloth; then gently pass the cloth over the inner surface of the foil (which is the side that does not contact the fabric). Do not lubricate the side that comes into contact with the fabric. After lubricating the unit, run the shaver in the "On" position over a piece of cloth for ten seconds to remove any excess oil from the face of the cutter. Reapply oil/spray after using the unit several times. SEE DIAGRAM.

TO OPERATE WITH ADAPTER

Insert adapter cord into the Clothes Shaver Plus^® fabric pill remover, plug into any AC household outlet. When not using adapter, remove from the Clothes Shaver Plus^® fabric pill remover, do not tangle, and store in a cool, dry place.

NOTE:
When using the AC adapter for an extended period of time, remove batteries from unit. When not using batteries for an extended period of time, remove from unit.

LINE CORD SAFETY TIPS

1. To insert plug, grasp it firmly and guide it into outlet.
2. To disconnect appliance, grasp plug and remove it from outlet. Do not pull or yank on the cord or appliance.
3. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. Please return it to our Service Department or to an authorized service representative.

DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE.

PROTECTIVE CAP WITH FOIL

HELPFUL HINT

The Clothes Shaver Plus^® fabric pill remover will operate more efficiently when the piece of clothing to be "shaved" is placed on a smooth, flat surface. On some fabrics, it may be best to stretch the material while "shaving." On other fabrics, additional pressure may bring better results. Always use an inconspicuous area of the clothing to determine the best method of operation.

The Clothes Shaver Plus^® fabric pill remover is not suitable for use on all fabrics or materials. Damage may result if used on very delicate fabrics such as angora wool. Some materials may have a deliberate texture by design, and application of the Clothes Shaver Plus^® fabric pill remover may act to remove such texture.

MAINTENANCE

At some point it may become apparent that the unit no longer shaves clothes as effectively as when it was new. Improved performance may be achieved by cleaning the cutting blades. If this becomes necessary, please follow the instructions below.

1. Be sure the On/Off switch is in the "Off" position, thebatteries have been removed from the unit, and the adapter has been unplugged from the wall outlet.
2. Remove the cutting foil by turning it counterclockwise.
3. Remove the cutting blade/fan assembly by gently pulling it outof the Clothes Shaver Plus^® fabric pill remover.
   
   Extreme care should be taken when handling the sharp blades of this assembly.
4. Clean the cutting blades with a soft brush, removing anybuild-up from the cutting edges.
5. Reassemble unit in the reverse order.

If operation is still not satisfactory, it may be necessary to order replacement cutting blades.

HOW TO ORDER REPLACEMENT PARTS FOR THE CLOTHES SHAVER PLUS® FABRIC PILL REMOVER

Complete coupon, clip and mail to:
SERVICE CENTER, 5980 Miami Lakes Drive; Miami Lakes, FL 33014

NOTE:
Be sure to enclose check or money order for full amount, payable to SERVICE CENTER. Allow four weeks for delivery. Price subject to change without notice.

PLEASE SEND ME THE FOLLOWING PACKAGE(S) OF REPLACEMENT PARTS, FOR THE CLOTHES SHAVER PLUS AT PRICE STATED:

Do not use this appliance to shave skin, as it may result in injury. The Clothes Shaver Plus^® fabric pill remover contains sharp cutting blades, and the same care should be exercised with this appliance as with any sharp cutting utensil.
Read all instructions carefully prior to use.

BATTERY INSTALLATION

The Clothes Shaver Plus^® fabric pill remover operates on four "AA" size alkaline batteries (not included).
To install batteries, first remove the battery cover by pressing the lock tab located on the bottom of the cover. Insert the batteries as indicated by the internal markings on the battery cover (+ and must be in the proper position for the unit to operate.) Snap the battery cover back on the unit.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Windmere Clothes Shaver Plus - Professional-Size Fabric Pill Remover Manual