Table of Contents
Advertisement
8. Functions and operation
1.WDR(Wide Dynamic Range) CONTROL
Light level is controllable with provided easy-to-use OSD menu that enables the
camera to be ideally Set up for the most of different levels of backlit or contrast lighting
situations.
LOW : Dynamic range level similar to that of CCD cameras.
NORMAL : Suitable for most indoor scenes without windows
or difficult lighting.
MIDDLE : Suitable for normal outdoor scenes and indoor
scenes that include windows.
HIGH : Maximum setting for harsh outdoor scenes.
2.BLC(Back Light Compensation)
OFF : Highlights in image are prioritized.
ON : Shadows in image are prioritized.
3.AGC(Auto Gain Control)
LOW : Low gain limit.
NORMAL : Normal gain limit.
HIGH : High gain limit.
4.White Balance
The Automatic White Balance provides an extensive Range
red or blue in varying light conditions.
ATW : Auto-tracking white balance mode.
AWB : Set white balance now and lock it.
12
8. Functions and operation
5.Fluorescent
Color Rolling Reduction.
OFF : Not used CRR.
CRR : This color roll reduction mode will work with manual
and auto-iris lenses. However, using it with
auto-iris lenses typically results in noticeable levels
of noise in shadows or dark areas in the image.
CRR2 : This color roll reduction mode works with
auto-iris lenses only.
Noise levels are reduced in shadows or dark areas
in the image compared to the noise levels present
when using the CRR mode,but dynamic range is
also reduced further.
6.ICR DVR TOOL
Ideal setting with IC Realtime DVR series.
OFF : Default Setting.
EDGE SERIES : EDGE series.
MAX SERIES : MAX series.
FLEX SERIES : FLEX series.
ELITE SERIES : ELITE series.
7.RS-485..
CAMERA# : Available to set up from 1 to 255.
PROTOCOL : Supports PELCO-D.
BAUD RATE : Select a baud rate.(2400, 4800, 9600, 19200)
RETURN. : Move to MAIN MENU.
*How to control OSD menu over RS485 :
1) Set communication speed on the camera to 9600bps.
2) Accord the ID of the camera with the of the
DVR or PTZ controller.
The factory default ID of the camera is CAM1.
3) On the DVR or PTZ controller, press 95 then
press PRESET or IRIS OPEN.(95+PRESET : Set Preset)
4) When the MAIN MENU pops up on the screen,
move the cursor Using a joystick to the desired menu to
control. When entering a Sub menu, press IRIS OPEN
momentarily.
13
Advertisement
Table of Contents
