Table of Contents
Advertisement
3.4 Disposables
1
2
Figure 14
WARNING
MAICO strongly recommends to use Sanibel eartips only. In case you want to purchase
further disposables, please contact MAICO or your local distributor.
3.5 Components/Replacement Parts
Some reusable components are subject to wear with use over time. MAICO
recommends that you keep theses replacement parts available (as appropriate for your
touchTymp device configuration).
3.6 Troubleshooting
Table 2 Troubleshooting
Problem
Reason
No start of
Probe
measurement
No start of
Probe tip
measurement
Screen is
frozen
Probe light
stays white
Transfer to PC
Connection to PC
not possible
Buttons are
No license
greyed out
Missing
calibration
Combinations of
settings not allowed
NOTE: If there are any problems that you cannot solve yourself, please, contact your
customer service. It will be helpful to use the function Export error log (see section 5.6.20)
to send the customer service the data needed for solving the problem.
8511780 Rev. 4
Operation Manual touchTymp MI 26 and MI 36 Version
Operating the touchTymp will require the use of eartips –
either mushroom shaped (1) or umbrella (2) eartips
(Figure 14).
Eartips are intended for single-use only. These should be
discarded after use. They cannot be cleaned.
In case of re-use of the single-use equipment you
enhance the risk of cross contamination!
Suggestion
Make sure the probe is connected to the back of
the device correctly and the brackets are closed.
Otherwise, follow the suggestions in Probe tip.
1. Clean the probe tip as described in the
2. Use a new probe tip. If the system still does
3. Change the complete probe and check if the
Hold the Front key button for 10 seconds in
order to shut-off the device. Restart.
Turn off the device. Confirm/reconnect the probe
before restarting.
Make sure the USB/PC-connection is established
(PC connection license needs to be activated), the
PC software is opened and the device and the
connection icon
Purchase license if wanted.
transducer
Calibrate transducer.
Verify settings are correct.
manual. If the system still does not run
proceed with step 2.
not run proceed with step.
system is running.
is displayed green.
19
30/06/2021
Advertisement
Table of Contents
