XERO XTI 5.0 Installation Instructions

XTI 5.0 | INGROUND UPLIGHT CASE
INSTALLATION INSTRUCTION

1. Trough

2. Paver or Concrete

3. Leveling material

4. Brackets for leveling

5. Power feed inlet

6. Drainage material

7. Drainage hole

1
Identify contents
Bracket pre-
attached to trough
2 3
Install case in suitable location making sure it is level
2 5 2
Ensure that the case is installed into a free draining
location with drainage material underneath
Perform a drainage
test once case is
installed to ensure that water free drains.
Luminaire must not be immersed in water for more than 30 minutes
2 2 7
If more information is required please contact your local representative by going to
AUSTRALIA HONG KONG
1
Trough
Instruction
Sheet
Pave or finish groundworks
MALAYSIA NEW ZEALAND
3 4 5 6
2
2
locate the correct
case for each luminaire
2 4
protective film
Maintain width of opening with supplied disposable
brackets - (Make sure the protective film is not removed
until luminaire installation takes place)
2 6 2
Install power feed cables - making sure that the
connections point is in an enclosure
For installation of the
XTI | 5.0 Inground Uplight IP67 IK10+
please turn over page
xerolighting.com/contacts
SINGAPORE UAE
disposable brackets
TOP VIEW
or email us at headoffice@xerolighting.com
UNITED KINGDOM UNITED STATES
1
2
3
4
5
6
7