Traxxas 1/16 E REVO 71054 Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. 1/16 E REVO 71054
  6. Owner's manual
Traxxas 1/16 E REVO 71054 Owner's Manual

Traxxas 1/16 E REVO 71054 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 71054
owner
s manual
'

Advertisement

Table of Contents
loading

Related Manuals for Traxxas 1/16 E REVO 71054

Summary of Contents for Traxxas 1/16 E REVO 71054

  • Page 1 MODEL 71054 owner s manual ’...
  • Page 2 Radio Frequency (RF) Exposure Information The radiated output power of the Traxxas LP Device is below the Industry Canada (IC) radio frequency exposure limits. The antenna for this transmitter must not be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-transmitter procedures. Co-location means having a separation distance of less than 20 cm between transmitting antennas.

  • Page 3: Before You Proceed

    Traxxas 6200 Traxxas Way, accompanying materials to prevent serious damage to your All of us at Traxxas want you to safely enjoy your new model. Operate McKinney, Texas 75070 model. Failure to follow these instructions will be considered your model sensibly and with care, and it will be exciting, safe, and fun Phone: 972-549-3000 abuse and/or neglect.

  • Page 4: Batteries And Battery Charging

    • Use the supplied charger to charge the included battery. of the installation and/or use of LiPo batteries in Traxxas products. Previous experience with radio controlled models is man No previous experience with radio See “Charging the Battery Pack”...

  • Page 5: Tools, Supplies, And Required Equipment

    R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife 6-cell 2/3A NiMH battery NiMH battery charger Body clips •...
  • Page 6 Rocker Front Bumper Front Body Mount Oil Shock Electronic Speed (Damper) Control (XL-2.5) Rocker Motor (Titan ® 12T) Front Traxxas High-Current Suspension Arm Connector Push Rod Transmission Steering Servo Spring Pre-load Rear Adjuster Suspension Arm Chassis 6 • 1/16 E-REVO...

  • Page 7: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom The Quick Start Guide is corners of Quick Start pages. not intended to replace the 1.

  • Page 8: The Traxxas Tq 2.4Ghz Radio System

    When flow is constricted, energy is converted to heat and is the electronic motor control inside the model. Electronic speed lost. Traxxas power systems are optimized to reduce electrical controls use power more efficiently than mechanical speed resistance and the resulting power-robbing heat.
  • Page 9 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Transmitter - The hand-held radio unit that sends throttle and IMPORTANT RADIO SYSTEM PRECAUTIONS steering instructions to your model. • For maximum range, always point the front of the transmitter To prevent loss of radio range, toward the model.

  • Page 10: Transmitter And Receiver

    THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. RADIO SYSTEM WIRING DIAGRAM XL-2.5 Wiring Diagram The transmitter has two channels: Channel one operates the Channel 1 steering, and channel two operates the throttle. The receiver Steering Servo inside the model has three output channels.

  • Page 11: Installing Transmitter Batteries

    THE TRAXXAS TQ 2.4GHz RADIO SYSTEM INSTALLING TRANSMITTER BATTERIES INSTALLING THE RECEIVER ANTENNA Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery The receiver antenna and antenna tube To prevent loss of radio range, Antenna compartment is located in the base of the transmitter.
  • Page 12 15 to identify the code. resistance. Secure, long-lasting, and easy to grip, the Traxxas • Always use new or freshly charged batteries for the radio system. connector is engineered to extract all the power your battery has Weak batteries will limit the radio signal between the receiver and to give.
  • Page 13 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS Steering reversing procedure: 1. Press and hold the SET button on the transmitter for two seconds. Make certain the model’s The status LED will flash green. receiver antenna is properly 2. Turn and hold the steering wheel to the full left or full right installed before operating position (it does not matter which position you choose).
  • Page 14 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM 7. Gently operate the throttle trigger to ensure that you have USING THE RADIO SYSTEM forward and reverse operation, and that the motor stops when The TQ 2.4GHz Radio System has been adjusted at the factory Using Reverse: While driving, the throttle trigger is at neutral.
  • Page 15 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Higher Speeds Require Greater Distance TRANSMITTER LED CODES The faster you drive your model, the more quickly it will near the LED Color / Pattern Name Notes Failsafe limit of radio range. At top speeds, models can cover anywhere...

  • Page 16: Adjusting The Electronic Speed Control

    ADJUSTING THE ELECTRONIC SPEED CONTROL XL-2.5 Battery Settings (Low-Voltage Detection Setting) 1. Disconnect one of the motor wires between the XL-2.5 and XL-2.5 ESC Specifications The XL-2.5 electronic speed control is equipped with built-in Low-Voltage the motor. This is a precaution to prevent runaway when Detection.
  • Page 17 ADJUSTING THE ELECTRONIC SPEED CONTROL 7. To turn the XL-2.5 off, press and hold the EZ-Set button for 1½ seconds or 4. The LED will blink and then turn solid green (Low-Voltage Detection ACTIVE) until the red LED turns off. or red (Low-Voltage Detection DISABLED).

  • Page 18: Driving Your Model

    DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions on run time is how the model is driven. Run times may decrease when driving and making adjustments to your model. Before you go on, the model is driven repetitively from a stop to top-speed and with here are some important precautions to keep in mind.
  • Page 19 (run the motor slowly) until the excess water can run out. Applying full • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not throttle to a motor full of water can cause rapid motor failure. Your subject it to wet conditions such as rain.
  • Page 20 (B). • Stub axle housing bearings: Remove, clean, and re-oil the bearings. 3. Apply a small bead of silicone grease (Traxxas • Front and rear differential: Remove, disassemble, clean, and re- part #1647) to the wire clamp (C).

  • Page 21: Tuning Adjustments

    TUNING ADJUSTMENTS Your model is factory-tuned for optimum performance in a Shock Oil wide variety of off-road conditions. To tailor the performance The 4 oil-filled shocks (dampers) effectively control the suspension Important: The shocks are and handling of your model to suit your driving style and terrain, movement by preventing the wheels and tires from continuing assembled at the factory with the model has a number of adjustable features.
  • Page 22 TUNING ADJUSTMENTS Static Camber Adjustment TRANSMISSION TUNING The wheels can be set to have either Adjusting the Slipper Clutch A camber gauge (available positive or negative camber (see Your model is equipped with an at your local hobby shop) illustration below). The camber angle can be a useful tool for adjustable Torque Control slipper changes as the wheel moves up and...
  • Page 23 From the factory, both the differentials are filled with SAE 30,000W motor access and Spur Gear viscosity silicone oil. Only use silicone oil in the differentials. Traxxas gearing adjustment. sells SAE 10,000W and SAE 50,000W viscosity oil (see your parts list).

  • Page 24: Wheels And Tires

    If you wish to install tires with a diameter greater Incorrect gear mesh is the most common cause of stripped spur than 4 inches or 100mm, Traxxas suggests you configure the gears. Gear mesh should be checked and adjusted anytime a gear transmission for ‘underdrive’...

  • Page 25: Maintaining Your Model

    If the bottom of the shock is leaking, then it 4. Check the wiring for any frayed wires or loose connections. is time for a rebuild. The Traxxas rebuild kit for two shocks is 5. Check the mounting of the receiver and servo(s) and part #7062.
  • Page 26 26 • 1/16 E-REVO...
  • Page 27 1/16 E-REVO • 27...
  • Page 28 ’ MODEL 71054 6200 TRAXXAS WAY, MCKINNEY, TEXAS 75070 1-888-TRAXXAS 150709 71054OM-N-EN-R02...

Table of Contents