Table of Contents
Advertisement
SMART LOBE ACCESS UNIT
Connect pin 1 of the eight-wire UTP cable to the
positive terminal and pin 2 of the eight-wire UTP
cable to the negative terminal of the power supply.
3.2 Set-Up Procedures
The Smart Lobe Access Unit has a rate-selection
jumper, set to either 4 or 16 Mbps, that can be
accessed by opening the unit box. The CPU refers
to this selection after power-up. The factory-default
setup is 16 Mbps.
Connect the unit to an external 11–35 VDC adapter
(typically a 12-VDC, 300-mA adapter).
Remote feeding can be used as a primary or backup
power source when using 8-wire UTP (see Figure
3-3).
3.3 Electrical Installation
Connect the Smart Lobe Access Unit to an external
11–35 VDC power source. Connect the cable
between the unit's MAIN connector and the MAU.
Connect the cable between the unit's SUB connector
and the workstation's token-ring adapter card port.
17
Advertisement
Table of Contents
