Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for ON Control AP01
- Page 1 AP01 Alarm panel MANUAL...
- Page 2 SUSA, which then removes the fault alarm in the AP01. The AP01 is only compatible with the software version FW 3.0 or later in the SUSA unit. Audible alarm 50dB(A) with a button to mute the alarm.
- Page 3 GENERAL SYSTEM OVERVIEW A typical example is illustrated below with three AP01 units connected in series to the SUSA unit. The AP01 displays alarms for faults that occur locally in the SUSA and all slave units via IS-BUS. You can also visit our website oncontrol.se...
- Page 4 A and B alarms in the fire protection area belonging to the SUSA and its system are forwarded to the AP01. An audible alarm in all AP01 units sounds and the red Profcon AB LED goes on at the same time to indicate the fault. The Victor Hasselblads gata 9 S-421 31 Västra Frölunda, Sweden...
- Page 5 SPECIFICATION Compatibility Power supply SUSA with FW 3.0 or later Power is supplied from the SUSA unit as shown on page 4. Maximum configuration Ambient temperature Up to three units can be connected in series to the SUSA master unit. Max +35 °C, min -5 °C Installation Weight...
- Page 6 PROFCON AB Victor Hasselblads gata 9 421 31 Västra Frölunda Sweden Tel: +46 (0)33 25 65 70 Web: oncontrol.se On Control is a registered trade mark of PROFCON AB MANUAL v1.01 6 / 6...
Need help?
Do you have a question about the AP01 and is the answer not in the manual?
Questions and answers