Toro TimeCutter SS 4260 Operator's Manual page 35

5
3
4
Figure 50
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
9. Loosen the rear locking nut on the hanger bracket
(Figure 51).
3
4
Figure 51
1. Hanger bracket
2. Rear locking nut
10. Loosen the side locking nut on the hanger bracket just
enough to allow the hanger to be adjusted (Figure 51).
Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
equivalent to 6.35 mm (1/4 inch), while a single side is
3.18 mm (1/8 inch) as shown in Figure 52).
11. Adjust the height of the mower deck to the desired
height.
G015323
1
2
4. Side locking nut.
5. Side carriage bolt
1
2
G015324
3. Side locking nut, slotted
position.
4. Adjustment notches
1
2
1. 0.25 inch
12. Stop the deck at the adjusted position and tighten the
side locking nut on the hanger bracket to hold the new
position (Figure 51).
13. Tighten the rear locking nut on the hanger bracket.
14. Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope (page 35).
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 7.9 mm
(5/16 inch) lower than the rear of the mower, adjust the blade
level using the following instructions:
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Set the height-of-cut lever to middle position.
Note: Check and adjust the side-to-side blade level if
you have not checked the setting; refer to Side-to-Side
Leveling (page 34).
4. Carefully rotate the blades so they are facing front to
rear (Figure 53 and Figure 54).
35
G015325
Figure 52
2. 0.125 inch