Troubleshooting - AEG F34300VI0 User Manual

• If you regularly use short duration
programmes, these can leave
deposits of grease and limescale
inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per
month.

11. TROUBLESHOOTING

If the appliance does not start or it stops
during operation, before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with
the help of the information in the table.
WARNING!
Repairs not properly done
may result in serious risk to
the safety of the user. Any
repairs must be performed
by qualified personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The end indicator flashes 1 time in-
termittently.
• Acoustic signal sounds 1 time in-
termittently.
• To maintain the performance of your
appliance at its best, we recommend
to use monthly a specific cleaning
product for dishwashers. Follow
carefully the instructions on the
packaging of the product.
With some problems the end indicator
flashes intermittently indicating a
malfunction.
The majority of problems that can
occur can be solved without the need
to contact an Authorised Service
Centre.
Possible cause and solution
• Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no damaged fuse in
the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The
duration of the procedure is approximately 5
minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water sup-
ply is not too low. For this information, contact
your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
ENGLISH 15