Gigabyte GA-Z87X-UD5H User Manual page 76

C. Configuring a RAID array
Create a RAID Array:
Move the selection bar to HBA 0: Marvell 0 and press <Enter>.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
HDD 0: ST95005620AS
HDD 1: ST95005620AS
Help
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Under Free Physical Disks, use the <Space> key to select the hard drives to be included in the RAID array.
The selected hard drive will be marked with an asterisk (*). After selecting the hard drives, press <Enter> to
proceed (Figure 3).
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Configure -> Select free disks
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* HDD 0: ST95005620AS
* HDD 1: ST95005620AS
Help
Use space bar to select the free disks to be used in the array.
ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return
Configuring SATA Hard Drive(s)
Information
Vendor ID : 1B4B
Device ID : 9230
Revision ID : A0
BIOS Version : 20291.24369.82.6535
Firmware Version : 2.3.0.1046
PCIe Speed rate : 5.0Gbps x2
Configure SATA as : AHCI Mode
Supported Mode : RAID 0 RAID 1 RAID10
: Capacity Safe
Figure 2
Information
Port ID : 1
PD ID : 1
Type ID : SATA PD
Status : Unconfigured
Size : 465.7GB
Feature Support : NCQ 3Gb/s 48Bit
Current Speed : 3Gb/s
Model : ST95005620AS
Serial : 5YX01W4H
FW version : SD22
Figure 3
- 76 -