1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 51.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Take the tool out of the new keyboard packaging. Insert the tabs
TrackPoint buttons and the trackpad
TrackPoint buttons. Then, remove the two TrackPoint buttons
Note: If your new keyboard is not shipped with the special tool shown in the following procedure, you
can use alternative tools to pry up the TrackPoint buttons.
4. Loosen the screws that secure the keyboard.
1
. Slightly pivot the tool downward
a
and
b
into the slot between the
2
to release the left and right
3
.
.
Chapter 7
CRU replacement
57