Philips 42PFL7403/60 Manual page 27

If you want to rename, reorder or uninstall stored
channels, see section 6.3 Rearrange channels.
Step 4 Clock, time zone and daylight saving
selection
Only available when the country selected supports
digital broadcasts.
Go to a next step if this step is not applicable.
‡ Press œ to select Clock.
® Press π to enter.
Ò Press o or œ to select Auto clock mode.
† Press π to enter.
Installation Clock
... Auto clock mode
Preferences Time zone
Connections assist. Daylight saving
Rename devices
Audio setup
Decoder
Clock
Factory settings
Auto clock mode
Select Automatic to instruct your TV to always get
the time correctly. Time zone and Daylight saving
correction are automatically set.
Select Manual when Universal Time Coordinated
(UTC) is not available in your area.
Time zone/Daylight saving
When you selected Auto clock mode manually,
select your local time zone and choose between
Standard (winter) and Daylight saving time
(summer).
Channel installation
6.2 Analogue: Manual installation
You can tune-in analogue TV channels channel by
channel manually with Manual installation.
6.2.1 Select the system
‡ Press Menu.
® Select Setup > Installation > Channel
installation > Analogue: Manual installation.
Ò Press π to enter the Manual installation menu.
System is highlighted.
† Press π to enter the System list.
º Press o or œ to select your country or part
of the world where you are now located.
◊Press p to return to the Manual installation
menu.
Channel install... Analogue: Manual...
Automatic install... System
Installation update Search
Start-up message Fine tune
Store as new ch...
Rearrange
6.2.2 Search for and store a new channel
‡ Press Menu.
® Select Setup > Installation > Channel
installation > Analogue: manual installation >
Search.
Ò Press π to enter the Search menu.
† Press the red key to enter the frequency
yourself or press the green key to search for a
next channel.
à Tip
If you know the frequency, enter the three numbers
of the frequency with the number keys of the
remote control.
º Press p when the new channel has been
found.
◊Select Store as new channel to store the new
channel under a new channel number.
‹ Press π to enter.
≈Press .
OK
Done appears.
Ú Press Menu to quit the channel installation
menu.
25