Hunter 50322 Installation Manual page 9

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Socket
Glass
Socket
Ring
Remove the socket rings from the sockets. Install
the glass onto the sockets. Install the socket
rings onto the sockets. Tighten them by turning
Repeat x3
clockwise by hand.
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket Downrod
2 of 6
Light Kit Screw
bag
5
Partially install two of the light kit screws found in
the hardware bag. Align the notches in the sides
of the lower switch housing with the screws on the
upper switch housing. Twist the lower switch housing
clockwise to lock into place.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Fan style may vary.
Hanging Fan Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 6
Light Kit Screw
bag
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the last light kit screw.
Tighten all three screws securely.
IMPORTANT
NOTE: Blades will need to be rotated to access all
screw holes.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades Light
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
ON
8
Glass/Bulbs