Table of Contents
Advertisement
Changing a wheel
352
The tightening torque must be
18 lb-ft (25 Nm).
i
Note that the hub cap should be tightened
to the specified torque of 18 lb-ft (25 Nm).
Mercedes-Benz recommends that you have
the hub cap installed at a qualified specialist
workshop.
Using lug wrench =, loosen the bolts on the
X
wheel you wish to change by about one full
turn. Do not unscrew the bolts completely.
The jacking points are located just behind the
front wheel housings and just in front of the rear
wheel housings (arrows).
Mercedes-AMG vehicles and vehicles with
AMG equipment: to protect the vehicle body,
the vehicle has covers installed next to the jack-
ing points on the outer sills.
Mercedes-AMG vehicles and vehicles
X
with AMG equipment: fold cover ? up.
Position jack B at jacking point A.
X
Make sure the foot of the jack is directly
X
beneath the jacking point.
Turn crank C clockwise until jack B sits
X
completely on jacking point A. The base of
the jack must lie evenly on the ground.
Turn crank C until the tire is raised a maxi-
X
mum of 1.2 in (3 cm) from the ground.
Advertisement
Table of Contents
