Table of Contents
Advertisement
You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan's box.
Do this first!
To avoid possible electrical shock, before
OFF
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Option 1:
Machine Screws
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
For angled ceilings,
point opening
toward peak.
1
Remove the pre-installed
setscrew so that the
downrod can be inserted.
Note:
Fan style may vary.
Ceiling Bracket
Downrod
Installing the Ceiling Bracket
WARNING
Installing the Blade Irons
2
Align the spacer with the holes on top of the motor. Lightly
attach blade irons to the motor through the spacer with
screws found in the hardware bag
tighten after screws are attached.
Hanging Fan
Wiring
Option 2:
Wood Screws
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64" pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the
hardware bag.
3
6 of 6
Blade Iron Screw
bag
Lower the top housing onto the top of the motor.
Install the three top housing screws found in the
, then securely
Canopy
Blades
Hunter Pro Tip:
The machine screws are the ones
that came with your outlet box.
Washer
bag
Wood Screw
3 of 3
Top Housing Screw
bag
hardware bag.
Upper Switch Housing
Reverse
1886
x2
x2
4
Advertisement
Table of Contents
