Advertisement
Connecting the Mixer Outputs
Output to an Amplifier
To play the mixer's output signal through your speaker system (for events such as parties, dances,
conferences, etc.) connect an audio patch cord (not supplied) from the mixers AMP L and R jacks
to your receiver amplifier's left and right input jacks.
This mixer features two kinds of output jacks for you to choose from: RCA style and 1/4" type. DO
NOT USE BOTH SIMULTANEOUSLY.
Output to a Tape or Digital Audio Recorder
To play the mixer's output signal through your speaker system (for events such as parties, dances,
conferences, etc.) connect an audio patch cord (not supplied) from the mixers REC L and R jacks
to your receiver/amplifier's left and right input jacks.
Booth Output
To monitor the mixer output to a second set of speakers in the DJ booth (or in a remote location)
connect an audio patch cord (not supplied) from the mixers Booth L and R jacks to your secondary
amplifier's left and right input jacks.
CAUTION: In order to avoid sudden unpleasant sound output,
adjust the output devices controls to these settings before you
connect the mixer's output jacks to these devices' input jacks.
OUTPUT DEVICE
Tape Deck
Amplifier/Receiver
6 – PYRAMID Mixer Owner's Manual
CONTROL
SETTING
POWER
OFF
POWER
OFF
TONE
FLAT
0
0
CENTER
Using Headphones
Plug a pair of stereo headphones (not supplied) with a 1/4" jack into the Phones input. Using
headphones not only affords you the opportunity to listen privately, but also enables you to monitor
("cue") the incoming audio sources so you can locate an exact passage or section before mixing it
in. It also gives you the opportunity to set up the relative volume level of the upcoming passage
before it joins the mix.
Listen Safely! Please observe the following:
Do not listen at extremely high volume levels. Extended,
high-volume listening can lead to permanent hearing loss.
Follow these guidelines to protect your hearing, especially
when using headphones.
Always start by setting the volume level to the lowest
possible level before listening.
Put headphones on, and then gradually increase the
volume as necessary.
Once you set the volume level do not increase it. Over
a period of time, your ears adapt to a volume level and there
is a temptation to increase it. Even though such an increase
may not cause discomfort, it might still damage your hearing.
Connecting the Lamp
If you wish to intall a console lamp (not supplied), simply insert the plug end of an appropriate
12V/3W gooseneck style or similar lamp into the lamp socket provided in the upper right corner of
the mixer control panel. Power is supplied to this lamp when the mixer power switch is turned on.
Stereo Headphones
12V/3W lamp
PYRAMID Mixer Owner's Manual – 7
Advertisement
