GE JBP85 Owner's Manual page 31

Cleaning the glass cooktop.
Clean your cooktop after
each spill.
Scotch-Brite ® Multi-Purpose
No Scratch scrub pad
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under "To Order Parts"
section on next page.
NOTE: Razor blade is packed
inverted for safety reasons. Prior
to use, the blade must be rotated
and reinserted into slot. Do not
use a dull or nicked blade.
Control Lockout
(on some models)
Begin by locking the cooktop;
see the Control Lockout section.
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama Bryte ® , on the glass
cooktop. Other creams may not be as
effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with the cooktop
cleaning cream. This helps protect
the top and makes clean-up easier.
Daily use of the cooktop cleaning
cream will help keep the cooktop
looking new.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than
BLUE Scotch-Brite ® Multi-Purpose No Scratch
scrub pads by 3M.
Allow the cooktop to cool.
Spread a few drops of Cerama
Bryte ® to the entire burned residue
area.
Using the Scotch-Brite
rub the residue area, applying
pressure as needed.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Spread a few drops of Cerama
®
Bryte to the entire burned residue
area.
Hold the razor scraper at
approximately a 45° angle against
the glass surface and scrape the
soil. It will be necessary to apply
pressure to the razor scraper in
order to remove the residue.
Keep a small amount of cream on
the residue as you scrape.
Shake the cleaning cream well.
Apply a few drops of the cream
directly to the cooktop.
Use a paper towel or sponge to
clean the entire cooktop surface.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after
all residue has been removed,
polish the entire surface with
Cerama Bryte
® blue pad,
After scraping with the razor
scraper, use the Scotch-Brite
blue pad to remove any
remaining residue.
For additional protection, after all
residue has been removed, polish
the entire surface with Cerama
Bryte
GEAppliances.com
® and a paper towel.
®
® and a paper towel.
31