Table of Contents
Advertisement
Available languages
Available languages
3
Installation
Before the calling the nearest Authorized
Service for the installation of the dryer, en-
sure that electrical installation and water
drain is appropriate referring to the user's
manual. (See 3.3 Connecting to the drain
and 3.5 Electrical connection) If they are
not suitable, contact a qualified electrician
and technician to make necessary arrange-
ments.
C
Preparation of the dryer's location
as well as the electrical and waste
water installations is under cus-
tomer's responsibility.
A
Prior to installation, visually check
if the dryer has any defects on it. If
the drier is damaged, do not have it
installed. Damaged products cause
risks for your safety.
A
Let your dryer wait for 12 hours
before starting to use it.
3.1 Appropriate installation
location
•
Install the dryer on a stable and level
surface.
•
Dryer is heavy. Do not move it by your-
self.
•
Operate your dryer in a well ventilated,
dust-free environment.
•
The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and tape.
•
Do not cover the ventilation grills of the
dryer.
•
There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
•
Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
•
Place the dryer at least 1 cm away from
the edges of other furniture.
•
Your dryer can be operated at
temperatures between +5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer
will be adversely affected and it can get
damaged.
Dryer / User Manual
•
The rear surface of the tumble dryer
shall be placed against a wall.
B
Do not place the dryer on the power
cable.
3.2 Removing the
transportation safety
assembly
A
Remove the transportation safety
assembly before using the dryer for
the first time.
•
Open the loading door.
•
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with
•
Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Check that no part of the trans-
portation safety assembly remains
inside the drum.
3.3 Connecting to the drain
In products equipped with condenser unit,
water accumulates in the water tank during
the drying cycle. You should drain accumu-
lated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining
the water collected in the water tank.
Connecting the water drain hose
1-2 Pull hose at the behind of the dryer
by hand in order to disconnect it from
where it is connected. Do not use any
tools to remove the hose.
3
Connect one end of the drain hose
supplied with the dryer to the
connection point from where you
removed the hose of the product in
previous step.
XX
XX.
41 / EN
Advertisement
Table of Contents
