Warranty FIVE (5) YEAR LIMITED WARRANTY A thorough inspection must be made before installation and any damage must be promptly reported. We will not be liable for failures or damage that could have been discovered or avoided by proper inspection and testing prior to installation. Conglom Kitchen &...
Pre-Installation TOOLS/MATERIALS REQUIRED (NOT SUPPLIED) Phillips Pipe wrench Flat screwdriver screwdriver Electric drill with 1-1/4”(32mm) hole Plumber’s putty PACKAGE CONTENTS Carefully check the the package contents for damage and/or missing parts prior to installation. If there is any damage or if you are missing parts, do not proceed with the installation.
Installation REMOVAL OF OLD UNIT CAUTION: Risk of electric shock. Turn off electric power at fuse box or circuit breaker before removing old unit. General instructions - your model may vary. NOTE: CAUTION: Be sure to support the disposal when removing the mounting ring or it may fall. Before starting this step, turn off the electrical power at the circuit breaker or fuse box.
Installation (continued) INSTALLATION OF MOUNTING ASSEMBLY Top supporting ring NOTE: Top supporting ring screw Pay close attention how the parts come assembled, as they have been correctly assembled by the factory (see Fig. 5). This food waste disposer has been designed to operate on 110-120 Volt, 8.8A, 60 Hz and 930W.
Installation (continued) Slot If at any time the bottom supporting ring becomes disengaged from the body of the waste disposer, then: 1. Align the slot in the bottom supporting ring with tab on the waste disposer body. 2. Lower the bottom supporting ring and make the slot fit in the tab.
Installation (continued) CONNECTING THE DISPOSER TO THE MOUNTING ASSEMBLY Fig. 11 Elbow - Adjust the disposer position to make the elbow line up Trap with the trap (see Fig. 11). Disposer body Reset Button - The disposer must be installed so that the reset button is readily accessible (see Fig.
Installation (continued) 1/3 turn Turn the bottom supporting ring 1/3 of a turn counter- clockwise and repeat the mounting procedure described above (see Fig 13). Fig. 13c - Connect the bottom of the elbow to the trap by tightening the slip nut (Fig. 14). - Run water and check all connections for leaks.
Operation TESTING AND OPERATION - Remove sink stopper. Turn on a medium flow of cold water. TIPS FOR SUCCESSFUL OPERATION - Turn switch to ON position; your motor is turning at full speed - Be sure disposal is empty before using your dishwasher and ready to use.
Troubleshooting Before seeking repair or replacement, we recommend that you review the following: Problem Solution The disposer is making loud noises. Other than the noises during grinding of small bones and fruit pits, these are usually caused by accidental entry of a spoon, bottle cap or other foreign objects.
Service Parts If you are missing parts or require replacement parts, please contact our customer service team at cs@conglomkb.com or 1-888-449-9194 (Service available in English and French, Monday - Friday from 8:30 am - 5:00 pm EST). Identify the required part(s) and have the part number(s) ready.
Page 13
Imported by: St-Laurent, Québec, H4S 2C3 1-888-449-9194 | cs@conglomkb.com (service available in English and French, Monday - Friday from 8:30 am - 5 pm EST) www.conglomkb.com Made in China...
Need help?
Do you have a question about the 681-4009 and is the answer not in the manual?
Questions and answers