Advertisement
Consult a qualified electrician or service agent if the grounding
instructions are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
If the power supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similar qualified person in order to
avoid hazard.
Children should be supervised to ensure that they do not play with the
appliance.
Each machine is tested for water intake and drainage during
production. Therefore, there may be water residues or traces
of water inside the washing tub, which is a normal
phenom
MADE
HINA
MEM
id'.0, 1 1NO:We.„t
glaima
XQB5
10
Warning:
This appliance is not intended for use by persons (including children)
whose physical, sensory or mental capabilities may be different or
reduced, or who lack experience or knowledge, unless such persons
receive supervision or training to operate the appliance by a person
responsible for their safety.
AUTOMATIC
WASHING MACHINE
Advertisement
Table of Contents
Need help?
Do you have a question about the XQB50-2010 and is the answer not in the manual?
Questions and answers
Won’t spin out water
The Nictemaw XQB50-2010 may not spin out water if the water level is below the minimum required, as the impeller will not turn. Additionally, spin drying is forbidden for certain items like down jackets, wool, and fur blankets, which could also prevent spinning if such items are loaded.
This answer is automatically generated
Where is the filter in the back of the machine
The filter in the Nictemaw XQB50-2010 washing machine is located at the bottom. You need to hold the handle of the filter and press to put it in.
This answer is automatically generated
What size is the drive belt?
The size of the drive belt for the Nictemaw XQB50-2010 is not provided in the context.
This answer is automatically generated
Washer is not agitating
The Nictemaw XQB50-2010 washer may not be agitating due to several possible reasons:
1. Power Supply Issue – Ensure the washer is properly plugged into a grounded 3-prong wall outlet and receiving power.
2. Damaged Power Cord – If the power cord is damaged, it must be replaced by the manufacturer or a qualified service agent.
3. Water Level – The washer may not agitate if the water level is not properly set. Ensure the correct water level is selected.
4. Filter Blockage – A clogged filter can affect washing performance. Clean the filter regularly.
5. High-Foaming Detergent – Using high-foaming detergent can cause issues, potentially affecting agitation. Use a moderate amount of low-foaming detergent.
6. Control Panel Issue – If excessive detergent or water enters the control panel, it can cause malfunction. Ensure the control panel is dry and undamaged.
7. Internal Fault – If none of the above resolve the issue, contact a qualified service agent for maintenance.
If the problem persists after checking these factors, professional repair may be required.
This answer is automatically generated
A plastic rectangular part fell off when I put the washer on its side to insert the quiet plate. Where does the rectangular part go?
WHERE CAN I GET A PART FOR MODELXQB50-2010
I need parts
My washer gives the E1 reading repeatedly, but only when it is trying to drain. It will stop middrain multiple times in a cycle and need to be reset by opening and closing the lid. What can i do?
The tub is leaking in the portable 20 lb nictemaw washing machine