Table of Contents
Advertisement
Press and hold button 2,
3
or
#
wish to program.
Indicator lamp
1
flashes yellow.
%
It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
1
continues to flash yellow.
Point remote control
5
from a distance of
#
1 in (1 cm) to 3 in (8 cm) towards buttons
2,
3
or 4.
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
1
lights up green contin‐
R
uously. Programming is complete.
Indicator lamp
1
flashes green. Pro‐
R
gramming was successful. Additionally,
synchronization of the rolling code with
the door system must also be carried out.
If indicator lamp
1
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
4
that you
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronizing the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects,
R
are located outside the range of movement
of the door.
Driving and parking 125
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 2,
#
or
4
repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
3
Advertisement
Table of Contents
