Trotec BD6A Original Instructions Manual

Cross line laser
Hide thumbs Also See for BD6A:

Advertisement

Quick Links

BD6A
EN
ORIGINAL INSTRUCTIONS
CROSS LINE LASER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BD6A and is the answer not in the manual?

Questions and answers

Summary of Contents for Trotec BD6A

  • Page 1 BD6A ORIGINAL INSTRUCTIONS CROSS LINE LASER...
  • Page 2: Table Of Contents

    You can download the current version of the instructions and the EU declaration of conformity via the following link: • Do not swallow batteries! If a battery is swallowed, it can cause severe internal burns within 2 hours! These burns can lead to death! cross line laser BD6A...
  • Page 3 Never point it at people or animals. suspension of the laser must be disabled Trotec accepts no liability for damages resulting from improper before transport. use. In such a case, any warranty claims will be voided.
  • Page 4: Information About The Device

    Designation Note H button Do not use abrasive cleaners or solvents to clean the device. V button Battery compartment with cover Laser 1/4 inch tripod connection (bottom) On/off/lock switch Operating mode LED cross line laser BD6A...
  • Page 5: Available Accessories

    2 x Alkaline AA, 1.5 V batteries • Batteries are removed from the device Scope of delivery Operation • 1 x Cross line laser BD6A • 2 x Alkaline AA, 1.5 V batteries Inserting the batteries • 1 x Quick guide Insert the supplied batteries into the device before first use.
  • Page 6 ü The device stands on a level, horizontal surface. 1. Set the on/off switch (6) to position  ð The vertical and horizontal laser lines are switched on. ð The operating mode LED (7) is illuminated in green. +/- 3,5° cross line laser BD6A...
  • Page 7 ð Both laser lines are no longer aligned horizontally, but line back on. follow the inclination angle of the device. ð The vertical and horizontal laser lines are visible. 3. Press and hold the H button (1) for approx. 3 seconds to switch the device off. cross line laser BD6A...
  • Page 8: Maintenance And Repair

    • The device has been dropped or was subject to a hard impact. This may have lead to damages on the laser optics suspended on a pendulum. Send the device to the Trotec Service for inspection. Only one of both laser lines is visible: •...
  • Page 9: Disposal

    According to Waste Electrical and Electronic Equipment Regulations 2013 (SI 2013/3113) (as amended) and the Waste Batteries and Accumulators Regulations 2009 (SI 2009/890) (as amended), devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. cross line laser BD6A...
  • Page 10 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...

Table of Contents