Celestron ELEMENTS WindGuide- 2 In 1 Wind Measure Device Manual

How to use

For detailed instructions and additional information visit the Celestron website at www.celestron.com.
Power On – Press the "Mode" button for 2 seconds to turn on the unit. The LCD will display Wind Speed, Temperature and Battery Condition.
Unit of Wind Speed – Press the "Mode" button for about 3 seconds until "m/s" starts to blink. Press the "Set" button to navigate through the choices and press the "Mode" button to confirm your choice. The setting will be stored in your unit even after turning it off.
Power Off – Press the "Mode" button and the "Set" button at the same time for 1 second to power the unit off.
Wind Speed Measurement – Turn the unit off and back on. Press the "Mode" button for 3 seconds until the "m/s" starts to blink. Press the "Set" button to navigate the speed units (Km/h, ft/min, Knots, mph) and choices of wind speed measurement – "Cu" for current wind speed, "MAX" for maximum wind speed and "AVG" for average wind speed. Press the "Mode" button to confirm your choice.
Set the Temperature Unit – On the rear of the unit is a hidden switch key with "C/F" noted below it. Use a small pin (or other thin object) to press the key to convert the temperature reading between "C" and "F".
Wind Chill – When temperature drops below 32°F (0°C), the wind icon "WIND CHILL" will be indicated on the LCD.
Backlight Display – Press either button to activate the backlight. It will stay on for about 10 seconds. Auto Power Off – The unit will turn off automatically if it is not doing any operation for about 14 minutes.
Changing the Battery – When the battery icon is shown on the LCD, change the battery. Turn the battery compartment door with a coin in the direction indicated and use a very small flat screwdriver to remove the door cover. Replace the CR2032 battery with the "+" position facing up.
Then, put the battery cover back on and close.