design and technical specifications are subject to change without notice.
Serial Number:
Date Installed:
It is important that the name from whom you purchased your device and the name of the installer are recorded above. The installer is responsible for the correct
installation, start up and demonstrating the operation of this device. They are also responsible for issuing relevant certificates of compliance (these may differ from
state to state).
Issue 20
Single Models:
Combination Models:
BB260FS; FB260FS; BS260FS; BB260C; FB260C; BS260C
Manual
Note: Due to Malmet's Policy of continuous product improvement;
Operation, Maintenance and Installation Manual Foreword To obtain maximum life and efficiency from your Malmet Warming Cabinet and to ensure safe operation, please read this manual thoroughly and follow all instructions before operating the device. This manual provides information on the operation of the device. It is recommended that all persons operating the device have access to this manual for training purposes.
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual Safety Instructions - Warnings Please read and understand this manual before using this device, if this device is used in a manner not specified by the manufacturer protection by the device may be impaired.
Operation, Maintenance and Installation Manual 1.0 Design Parameters Single 105 Litre Blanket Warming Cabinet (Model B105BT) is designed to hold 4 blankets maximum; 2 per shelf maximum (depending on type of blanket). Both shelves are adjustable. Single 210 Litre Blanket Warming Cabinets (Models B210FS, B210C, B210WB, B210S) are designed to hold 16 blankets maximum;...
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual 1.1 Device Operation NOTE The Blanket Warming Cabinet is factory set to 60°C Before starting the device The device should be run initially on a power supply not protected by an earth leakage circuit breaker for approximately three hours.
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual 1.4 Changing the set temperature (lock out feature) AUTHORISED PERSONNEL ONLY Authorised operators can change the temperature by holding the up and down temperature buttons at the same time for a total of 5 seconds. The temperature can then be adjusted. The setting will revert back to tamper proof 5 seconds after the temperature is adjusted or if the up and down temperature buttons are not pressed within 5 seconds.
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual 2.0 Installation Floor Bench Skirt Floor Bench Skirt is factory fitted to the cabinet. To level, remove the four plastic plugs from the inside floor and adjust the feet by turning the slotted screw head. Once the device is level, replace the plugs.
Page 9
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual Warming Cabinets with Castors All warming cabinets should be located on a level floor surface and should never be operated on a sloping surface. Check that all swivel wheels are in lock position.
Page 13
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual B420FS Blanket Warming Cabinet Freestanding with Floor Skirt Note: This Blanket Warming Cabinet is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge.
Devices should have regular Test and Tag procedures undertaken. 3.2 Replacement of Safety Devices The following safety devices must be replaced and tested by a Malmet trained technician, failure to do so may impair the protection by the device. • Over Temperature Cut Out Switches •...
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual 3.3 Trouble Shooting Guide Problem Probable Cause Suggested Remedy Display not on or won’t turn on. No Mains power supply. Check power supply and lead plugged in. Power point not turned on.
(and paid for) by the owner. • It is the owner's responsibility to provide safe access to the device. Malmet, or any of its authorised service agents, may refuse to perform maintenance or warranty work if access is unsafe, as determined by Malmet or any of its authorised service agents acting reasonably.
Page 19
• To the extent permitted by law, no responsibility will be accepted for damage incurred as a result of, or incidental to, electrical surges or brown outs or for any other consequential damages. • If there is no certificate of compliance for plumbing or electrical, Malmet reserves the right to refuse service on non-compliant installations.
Page 20
HOW TO MAKE A CLAIM UNDER THIS WARRANTY If you believe there is a defect in a device you have purchased from Malmet, you must notify Malmet in writing of such defect, by sending an email (Notice of Defect) to info@malmet.com.au...
Page 21
Malmet Blanket Warming Cabinet Operation, Maintenance and Installation Manual Manufactured by Malmet (Australia) Pty Ltd ABN 95 001 717 791 www.malmet.com.au DCN:2969 P/N 8-M00-83-900...