Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mopec BK401
Summary of Contents for Mopec BK401
- Page 1 MOPEC USER MANUAL MOPEC LARGE SLIDE DRYING HOTPLATE - BK401...
-
Page 2: Table Of Contents
WARRANTY TERMS AND CONDITIONS INTRODUCTION Mopec’s Large Slide Drying Hotplate is designed to quickly and efficiently dry paraffin tissue sections. The rapid heating system ensures the hotplate is ready to use in less time, while the digital temperature control allows for accurate control of temperatures. Slides are placed on the six moveable rails at an angle to allow water to drain off, while heated air passes underneath the slides to reduce drying times. -
Page 3: General Notes
GENERAL NOTES 1. This product is designed for laboratory use only. Always follow good laboratory practice. 2. If this product is not used in accordance with these instructions then basic safety protection may be affected. 3. If damaged or in case of failure the power supply unit supplied with this product should be replaced with an equivalent power supply unit. -
Page 4: Power Lead & Connection To Electrical Supply
SPECIFICATION The Mopec Large Slide Drying Hotplate is designed to dry paraffin tissue sections efficiently while taking up a minimum of bench space in the laboratory. The hotplate features a matte black heated surface which is digitally controlled at a constant temperature and is combined with four movable rails which allow heated air to pass underneath the slides to accelerate drying. -
Page 5: Location
Temperature range: ambient to 95˚C (+/- 1˚C) at 20˚C Display: Digital Display with 0.5˚ accuracy. Safety: Class 1 cut out Heater power: 400 watts Power Supply: Dual Voltage 220-240V or 110-120V, 50-60Hz LOCATION The product must be placed on a smooth, level and sturdy work surface. Suitable for use in ambient temperatures 5°C to 40°C with a maximum humidity 80% (temperature 31°C) decreasing to 50% (temperature 40°C). -
Page 6: Cleaning Instructions
MINIATURE CIRCUIT BREAKERS Located at the rear of the instrument. In the event of a fault, push back in to reset. If fault situation continues, please contact your Service Engineer or Mopec. PORTABLE APPLIANCE TESTING Portable appliance testing should be carried out by a qualified person. -
Page 7: Setting Controller Offset Parameters
(offset). ROUTINE INSPECTION RECOMMENDATIONS Mopec recommends that a simple annual inspection be made for all Mopec laboratory equipment in order that any malfunction can be identified and rectified as early as possible. This is to ensure user safety and prolong instrument lifespan. -
Page 8: Warranty Terms And Conditions
4. Mopec will accept no liability, where in the opinion of the company the defect has been caused by damage due to the Customers failure to follow operating instructions, correct... - Page 9 It is the customers responsibility to ensure that the loan equipment is packed in the packaging provided by Mopec, in order that Mopec can arrange collection of the loan instrument. If the loan instrument is not packed and ready for collection within 48 hours of a repaired instrument being returned to the customer, costs for collection and equipment rental fee will be applied.
- Page 10 Low Voltage Directive 2014/35/EU EMC Directive 2014/30/EU We confirm the declaration: Mopec 800 Tech Row Madison Heights, MI 48071 Conforms with the requirements of the following standards: BS EN 61010-1:2010 BS EN 61010-2-010:2014 Safety requirements for electrical equipment for measurement, control and laboratory use.
Need help?
Do you have a question about the BK401 and is the answer not in the manual?
Questions and answers