Advertisement
Quick Links
HPE LSWM2XMGT2PM Interface Card (R9L65A) User
Guide-5PW100
Introduction
Product code
R9L65A
•
The switch models that the LSWM2XMGT2PM interface card is
applicable to might change over time. For the most up-to-date list of
applicable switch models, contact HPE Support or marketing staff.
•
The restrictions for using the LSWM2XMGT2PM vary by device model.
For more information, see the installation guide for the device.
Overview
The LSWM2XMGT2PM interface card provides two 10G/5G/2.5G/1000/100BASE-T
autosensing Ethernet port.
10G/5G/2.5G/1000/100BASE-T antosensing Ethernet port
Autosensing Ethernet
port LED
HPE description
HPE FlexNetwork 5140/5520
10GBASE-T MACsec 2p Mod
Ejector lever
Part number: 5200-8510
Alias
LSWM2XMGT2PM
1
BOM: 3101A135
Captive screw
Advertisement
Related Manuals for HPE LSWM2XMGT2PM
Summary of Contents for HPE LSWM2XMGT2PM
- Page 1 For the most up-to-date list of applicable switch models, contact HPE Support or marketing staff. • The restrictions for using the LSWM2XMGT2PM vary by device model. For more information, see the installation guide for the device. Overview The LSWM2XMGT2PM interface card provides two 10G/5G/2.5G/1000/100BASE-T...
-
Page 2: Specifications
Specifications Item Specification Ports 2 × 10G/5G/2.5G/1000/100BASE-T autosensing Ethernet ports Dimensions (H × W × D) 40.1 × 95.0 × 147.5 mm (1.58 × 3.74 × 5.81 in) Weight 0.3 kg (0.66 lb) Min power consumption 2.0 W Max power consumption 4.0 W Operation temperature –5°C to +45°C (23°F to 113°F) -
Page 3: Safety Precautions
LEDs The 1/10GBase-T autosensing Ethernet port LEDs are not affected by the port LED mode switching button on your switch. For more information about the port LED mode switching button, see the installation guide for the switch. LED Status Description 10G/5G/2.5G/1000/100BASE-T autosensing Ethernet port LED Steady green A link is present on the port and the port is operating at 10 Gbps. -
Page 4: Installing The Interface Module
Installing the interface module To Install the interface module: (1) Unpack the card. Insert the card slowly into the slot along the guide rails. (2) Rotate inward the ejector lever until the card is in close contact with the switch. (3) Use the Phillips screwdriver to tighten the captive screw on the card. -
Page 5: Verifying The Installation
(2) If the problem persists, contact Hewlett Packard Enterprise Support. Documentation To access documentation and support services, go to the Hewlett Packard Enterprise Support Center website: www.hpe.com/support/hpesc 5200-8510 The information contained herein is subject to change without notice. © Copyright 2022 Hewlett Packard Enterprise Development LP...