Installing The Interface Module; Removing The Interface Module - HPE LSWM2XMGT2PM User Manual

Installing the interface module

3
1
2
To Install the interface module:
(1) Unpack the card. Insert the card slowly into the slot along the guide rails.
(2) Rotate inward the ejector lever until the card is in close contact with the switch.
(3) Use the Phillips screwdriver to tighten the captive screw on the card.

Removing the interface module

1
3
2
To remove the interface module:
(1) Use a Phillips screwdriver to loosen the captive screw on the card.
(2) Hold the ejector lever to pull the card outward until the card is disconnected
from the connectors.
(3) Hold the card with both hands and take it out slowly.
4