Table of Contents
Advertisement
Configuring the Terminal Module
Terminal Module
Descriptions
Standard Terminal
Module
Chapter 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
All manuals and user guides at all-guides.com
This section gives guidelines to configure the terminal module, including:
•
Terminal Module Descriptions
•
Wiring Terminal Modules
•
Attaching a Terminal Module to the Multiplexer
•
Connecting the Analog Bus
The E1476A 64-Channel, 3-Wire Multiplexer module consists of a
multiplexer switch card and a spring clamp type terminal module. The
screwless terminals use a spring clamp terminal for connecting solid or
stranded wire. Connection is made with a push of a three-pronged insertion
tool (part number 8710-2127) that is shipped with the multiplexer.
If the spring clamp type terminal module is not desired, a crimp-and-insert
terminal module (Option A3E) and an interface to rack mount terminal panel
(Option A3F) are available. See "Configuring the E1586A Rack Mount
Terminal Panel" for details on using Option A3F.
Figure 1-8 shows the E1476A spring clamp standard terminal module
connectors and associated channel numbers. See "Multiplexer Front Panel"
for the connector pin-outs that mate to to terminal module.
Bank A
Terminals
Analog Bus to VM
(Input)
Figure 1-8. E1476A Standard Terminal Module
Bank B
Terminals
Analog Bus to VM
(
)
Getting Started 19
Advertisement
Table of Contents
