Phasak PH 7690 Quick Start Manual

POWER MANAGEMENT CARD
PMCARD - PH 7690
Compatible with PH 9210, PH9220, PH 9230
The Power Management Card allows a UPS/ATS
system and environmental sensor to be managed,
monitored, and configured.
Quick Start Guide
INSTALLATION GUIDE
Step 1. Hardware Installation
1. Remove the two retaining
screws of the expansion slot,
and then remove the cover.
2. Install the Power Management
Card into the expansion slot.
3. Insert and tighten the retaining
screws.
4. Connect an Ethernet cable to the
Ethernet port of the Power
Management Card.
NOTE: The Power Management Card is hot-swappable, so you do not
need to turn off the device to install it.
K01-3101000-01
U ni
ve rs
al
Li nk
T x/
R x
P M
C A
R D
U ni
ve rs
al
T x/
R x
P M
C A
R D
Universal Port
Universal
LINK Indicator Tx/Rx Indicator
Definitions for LED Indicators
Link LED color
The Power Management Card is not
connected to the Network/ or the Power
Off
Management Card power is off
The Power Management Card is connected to
On(Yellow)
the Network
Tx/Rx LED color
Off The Power Management Card power is off
On(Green) The Power Management Card power is on
- Receiving/transmitting data packet
Flash
- Reset finished
Step 2. Configure the IP address for the Power
Management Card
Method 1: Using the Power Device Network Utility
1. Install the Power Device Network Utility available for download on the
Network Power Management product web page at
http://www.powermonitor.software/#PowerDeviceSoftware.
2. After installation completes, run the "Power Device Network Utility".
3. The main dialog of the Power Device Network Utility program is shown
in Figure 1. The configuration tool will display all Power Management
devices present on the same network subnet. The "Refresh" button is
used to search the local network subnet again.
Figure 1. The main window of the "Power Device Network Utility" program.
4. Select the Power Management Card you are setting up. Click on the
Tools menu and select "Device Setup" or double click the Power
Management Card you want to configure.
5. You can modify the IP Address,
Subnet Mask, and Gateway
address for the Device MAC
Address listed in the Device
Network Settings window, as
shown in Figure 2. The factory
default IP Address is
192.168.20.177 and the default
Subnet Mask is 255.255.255.0.
6. Modify the IP, subnet mask or
gateway address. Enter the new
addresses into the corresponding
fields and then click "Save".
Ethernet Port
Link Tx/Rx
PMCARD
Condition
Figure 2. The Device Network setting window.