Videx VLF-H065A - Headlamp Manual

TECHNICAL PARAMETERS

1. Output.
2. Runtime.
3. Distance.
4. Intensity.
5. Correlated color temperature.
6. LED type.
7. Compatible battery.
8. Charging port type, voltage and current.
9. Charging time.
10. Dust and moisture protection level.
11. Impact resistance.
12. Product sizes.
13. Product weight (without battery).
14. Color: black.
15. Optical system type: optical lens
16. Materials: Aviation anodized aluminum, tempered glass.

Note: Runtime, Distance, Intensity and Charging time results tested with a stock battery Videx 18650 2200mAh. The above mentioned parameters may vary between environments and actual batteries used.

*The Turbo mode runtime is the accumulated time, including reduced output levels with the overheat protection enabled.

MAIN FEATURES

Maximum brightness 1200 lumens in a compact body;

Frosted optical lens for optimal balance between low and high beam;

Water resistance IP68 (short-term immersion under water to a depth of 2 meters);

Side magnet for various secondary mounting ways;

Both fast release holder and standard holder included;

Compatible with primary 2xCR123A batteries.

INCLUDED

• Headlamp VLF- H065A;
• Li-ion battery Videx 18650 2200mAh;
• Charging cable;
• Headband;
• Quick release holder;
• Standard holder;
• Spare O-rings;
• User's manual.

LIGHTING MODES

Turbo – maximum brightness

High – high brightness

Middle – medium brightness

Low – low brightness

Moon – minimum brightness

SOS – emergency signal

OPERATING INSTRUCTION

ON/OFF – press and hold the button for 0.5 seconds to turn on/off the light;

Modes selection – when the light is switched on, shortly press the button to switch between modes cyclically.

SOS mode – press and hold the button for 3 seconds. Short press again to exit SOS mode.

Lock/Unlock – with the light switched off, double press the button continuously within 0.5 seconds to lock the flashlight. The flash light will respond by appropriate double flicker. Double press again to unlock.

The headlamp automatically memorizes the last selected lighting mode (except the SOS mode) and applies it next time when turned on.

BATTERY STATUS INDICATION

With the light switched off, shortly press the button to see the battery status. The indication will last for 3 seconds. The battery status is also continuously displayed when the light is turned on.

Continuous green light - 100-80% charge;

Flashing green light - 79-50% charge;

Continuous red light - 49-25% charge;

Flashing red light - critical charge 24-1%.

CHARGING

Plug the USB-A socket of the charging cable into electrical outlet. Switch off the light, unscrew the protective cover counterclockwise and connect the charging cable to the headlamp port.

ATTENTION: primary CR123A batteries cannot be charged. When charging, the indicator glows red. When fully charged, the indicator glows green.

After a full charge, unplug the charging cable and screw the protective cover all the way in to prevent water and dust from entering the headlamp body.

© The original rechargeable batteries are supplied charged and can be used immediately after purchase, however it is recommended that the battery be fully charged before first use. The battery needs to be charged in time before it is completely discharged. During long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life.

BATTERY REPLACEMENT

1. Unscrew the battery cover counterclockwise;
2. Insert the battery according to the diagram shown on the outside of the headlamps body;
3. Screw the battery cover all the way in and test the device.

MAINTENANCE AND SAFETY INSTRUCTIONS

• For long-term storage, it is necessary to remove the batteries from the device.
• It is recommended to regularly lubricate the rubber seals and threaded parts of the headlamp to prevent premature wear and ensure the waterproof housing. If the rubber rings are damaged, they must be replaced.
• Lock the headlamp to avoid accidental activation during carrying and storage;
• ATTENTION. Avoid direct light into eyes as it may cause the eyes damage.
• The headlamp can accumulate a significant amount of heat when used for a long time, which can cause the body to become hot. Therefore, be careful to avoid burns.
• It is forbidden to shine the headlamp in a critical proximity to easily flammable substances in order to avoid fire.
• Do not use batteries other than those specified in the technical specifications.
• Do not disassemble the headlamp head as this may compromise performance and void the warranty.
• Do not charge the headlamp with CR123A batteries inside.
• Keep out of the reach of children.