Summary of Contents for DMI LED BALLOON LIGHT
- Page 1 BALLOON LIGHT dmitools.com 385.449.2700 OWNER’S MANUAL dmitools.com 385.449.2700...
- Page 2 Read this manual carefully before operating this machine. The Owner’s Manual should stay with the machine if it is sold. INTRODUCTION DO NOT THROW AWAY USER MANUAL Congratulations on your purchase of your LED Light Balloon. This manual includes assembly and product use information.
-
Page 3: Table Of Contents
IMPORTANT MANUAL INFORMATION TABLE OF CONTENTS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. This symbol is also used to indicate a hazardous situation which, if not avoided, could result in serious injury or death. -
Page 4: Safety Information
1. SAFETY INFORMATION 1.1 WARNING: FALLING OR TIPPING OVER NEVER touch the machine with wet hands or electrical shock may occur. Set up and place the tripod on a flflat level surface. Ensure that all legs of the tripod are completely Connect the ground lead of the machine to the ground extended and the screw knob on the bracket terminal of the power source. - Page 5 dmitools.com 385.449.2700...
-
Page 6: Control Function
4. PREPARATION 3. CONTROL FUNCTION & OPERATION 400 Watt LED Balloon Light control function is simple. Plug it in and flflip the ON/OFF Toggle Switch to ON. products come with a versatile molded plug with a folding ground prong as well as a ground clamp. Whenever available use the power cord plug utilizing the ground prong. -
Page 7: Tripod Preparation & Operation
Remove tripod from carrying case. Carefully stand the tripod upright, with the three legs pointing down and the LED Balloon Light mount on the top. Loosen the screw knob at the base then pull the legs apart spreading the 3 legs, while sliding the support bracket down until it stops. -
Page 8: Maintenance, Storage & Transport
MAINTENANCE We recommend cleaning the unit after every use. Before performing maintenance make sure the unit is turned off and unplugged from any power source. Remove the Balloon Light cover. The Balloon Light cover may be clean with warm water and a light soap solution. To clean the air fifilter fifirst remove the 1 screws on the air fifilter cover at the top of the LED unit. -
Page 9: Consumer Information
CONSUMER INFORMATION The Part Number and Serial Number can be found on the specififications sticker located on the side of the LED unit. These are your products identifification numbers. Please keep record of these numbers as well as the purchase date.
Need help?
Do you have a question about the LED BALLOON LIGHT and is the answer not in the manual?
Questions and answers