Advertisement

Quick Links

BRAD RETRO
RECORD PLAYER
1

Advertisement

Table of Contents
loading

Summary of Contents for Gadhouse Brad retro

  • Page 1 BRAD RETRO RECORD PLAYER...
  • Page 3: Table Of Contents

    CONTENT Introduction Safety Information Specification Accessories included Control locators Getting started Unpacking and power source Operation Audio Input Turntable function (LP) Bluetooth Function (BT) Aux-In function (AUX) Audio Output Brad’s stereo speaker Line-out RCA Replacing the needle Troubleshooting guide Maintenance and Care FCC statement...
  • Page 4: Introduction

    INTRODUCTION Thank you for purchasing Brad retro record player. To assure maximum satisfaction from this product, please read the in- formation and follow the instructions presented in this manual. Please keep the manual in an accessible location for future reference.
  • Page 5: Safety Information

    SAFETY INFORMATION WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EX- TENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
  • Page 6 fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with a cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use cau- tion when moving the cart/apparatus combination to avoid injury from tip-over.
  • Page 7 SAFETY INFORMATION For U.S. Models Federal Communications Commission (FCC) Compliance Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including inter- ference that may cause undesired operation.
  • Page 8 For European Models Declaration of Conformity This product conforms to all applicable EU directive requirements. We declare, under our sole responsibility, that this product complies with the standards: - Safety - Limits and methods of measurement of radio disturbance charac- teristics - Limits for harmonic current emissions - Limitation of voltage changes, voltage fluctuations and flicker - EU RoHS Directive, 2011/65/EU...
  • Page 9: Specification

    0/70mm full range Sensitivity 83± 3 dB/m/W Bluetooth Bluetooth version Bluetooth Standard version 5.0 Output Bluetooth Standard Power Class 2 Maximum Line of sight approx. 10 metre communication range Power Supply DC power adapter 9V/1A Power consumption 3 W Replacement stylus Gadhouse Stylus...
  • Page 10: Accessories Included

    ACCESSORIES INCLUDED 1. Brad record player 2. Stylus guard 3. 45 RPM adaptor 4. Power adaptor supply 5. User manual 6. Brad mat 7. Additional cable – dual RCA to stereo 3.5 mm mini-plug (female) 8. Additional cable – dual RCA to dual RCA (male) 9. Additional cable – 3.5 mm to 3.5 mm mini-plug 10.
  • Page 11: Control Locators

    CONTROL LOCATORS 1. Power Control Knob 10. Cue lever 2. Volume Control Knob 11. 45 RPM Adaptor 3. Function Control Knob 12. Dust Cover 4. Aux-In jack 13. Needle 5. Bluetooth Indicator 14. Platter 6. Speed Control Switch 15. Tone Arm 7.
  • Page 12: Getting Started

    GETTING STARTED Unpacking and power source 1. Remove packing material from Brad record player 2. Remove power adaptor from the gift box of Brad record player 3. Remove tie from adaptor 4. Set the record player properly on a flat, level surface 5. Open the dust cover (12) 6. Remove black-tie wrap from tone arm holder (9) 7. To begin using the turntable, remove the stylus guard by gently pull- ing toward yourself from front of needle (13) 8.
  • Page 13: Bluetooth Function (Bt)

    5. Adjust the volume control knob (2) to the desired sound level. 6. Slide the auto stop switch (7) to ON to operate the auto stop function. 7. At the end of the record, the tone arm (15) will stop automatically. You must return the tone arm to the tone arm holder manually.
  • Page 14: Audio Output

    in this product) into Aux-in jack (4). The other end will plug into the audio output jack of your device. (For more information on hooking up the ex- ternal device, see the device user manual.) Pitch control (18) Pitch Control, allows you to adjust the speed of Brad apart from stand- ard speed, More fast:By turning to the right.
  • Page 15: Replacing The Needle

    To maintain original performance, insist upon a genuine Gadhouse brand replacement stylus. Look for the Gad- house trademark on the needle packaging or check it out on the Gad- house online store (http://www.gadhouse.com)
  • Page 16: Troubleshooting Guide

    Needle (13) does not • Lower the lifter lever. lower onto record. • Make sure the replacing new needle is a genuine Gadhouse brand replacement sty- lus. (see more information under “Replac- ing the needle” topic) Music from record too •...
  • Page 17 Troubleshooting guide • Clean the record with a proper record- cleaning brush (check the product from Gadhouse online store) to remove build-up of dust & dirt in the grooves of the record. • Ensure the Needle (13) is in the correct position.
  • Page 18 Problem Troubleshooting guide The paired device con- • The Bluetooth reception is poor. Move the nects and disconnects device closer to this product or remove any constantly. obstacle between. • Ensure the length between device and product is not more than 10 Metre. •...
  • Page 19: Maintenance And Care

    Limited warranty The Brad record player is covered by a limited warranty. Details of the limited warranty are provided on the product website (http://www. gadhouse.com) or contact for further information via Brad model’s cus- tomer service e-mail: brad@gadhouse.com.
  • Page 20: Fcc Statement

    FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including inter ference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
  • Page 21 BRAD RECORD PLAYER USER MANUAL JP VERSION...
  • Page 22 付属品 1. 本体 2. スタイラスガード 3. EPアダプター 4. 電源アダプタ 5. 取扱説明書 6. スリッ プマット 7. デュアルRCA...
  • Page 23 部位説明 1. 電源ノブ 10. アームリフトレバー 2. 音量ノブ 11. EPアダプター 3. 機能ノブ 12. ダストカバー 4. 入力ジャック 13. カートリッジ 5. ブルートゥースランブ 14. プラッター 6. 回転数スイ ッチ 15. トーンアーム 7. オートストッ プスイ ッチ 16. RCA出力ジャック 8. ステレオスピーカー 17. 電源ジャック 9. トーンアームホルダー 18. Pitch control...
  • Page 24 操作方法 1. 電源ノブをONにしてください。 そして、 機能ノブをLPに合わせてください。 2. 再生したいレコードの設定スピードに合わせ、 回転数スイ ッチをスライドしてください。 3. 付属のスリッ プマッ トをプラッターに設置し、 レコードを載せてください。 4. アームリフトレバーを上げ、 再生したい溝の上までトーンアームを動かし、 アームリフトを 下げカートリッジをレコードに落とすと再生されます。 5. 音量ノブを操作し、 音量を調整してください。 6. オートストッ プスイ ッチをONにすることで、 オートストッ プモードになります。 7. レコードの再生が終わると、 プラッターが自動で停止します。 トーンアームを手動でトーンアームホルダーに戻してください。 8. ターンテーブルの使用が終わったら、 トーンアームをロックし、 スタイラスガードを装着し、 針を保護してください。 45 RPM レコードのセッティング 1.
  • Page 25 入力セッティング 1. 機能ノブをAUXに合わせてください。 2. 追加ケーブルを使用し外部デバイスを入力。 または、 RCA出力を行なう際に 選択します。 針の交換 針に触れないように注意しながら、 下の図のように取付 ・ 外しを行ないます。 カートリッジと 針に隙間がないよう、 装着をしてください。 ターンテーブルのパフォーマンスを維持するには、 純正の交換針を使用することを推奨します。 Take a needle off Replace new needle...
  • Page 26 トラブルシューティング 保証を有効にするために、 絶対に製品を修復しようとしないでください。 問題が発生した場 合は修復を依頼する前に、 以下の確認を行なってください。 問題が解決しない場合は、 ご購 入店舗に直接お問い合わせください。 作動しない ・ 電源コードがコンセントに差し込まれていることを確認し、 コネクタを電源ジャックに差し込んでください。 ・ 電源を切り、 再起動をしてください。 音が出ない ・ 音量ノブが上がっているか確認してください。 ・ スタイラスガードが取り外されているか確認してください。 ・ 針の位置が正しいか確認してください。 アームが動かない ・ ”開梱と電源”をお読みください。 針がレコードに落ち ・ アームリフトレバーを下ろしてください。 な い ・ 純正の針であることを確認してください。 再生スピードが異なる ・ 回転数スイ ッチを確認してください。 レコードが滑ってしまう ・ ターンテーブルが水平に設置されているか確認してください。 ・...
  • Page 27 ペアリング後のデバイ ・ 受信が不十分です。 デバイスを本体に近付けたり、 障害物を スが絶えず接続と切断 取り除いてください。 を繰り返します ・ デバイスと本体の距離が10mを超えないようにしてください。 ・ デバイスが通話を発信または終了すると、 デバイスは接続と 切断が行なわれるものがあります。 本体の誤動作ではありま せん。 ・ 一部のデバイスでは、 省電力機能として、 Bluetooth接続が 無効になることがあります。 本体の誤動作ではありません。 AUXデバイスからの音 ・ 接続されているデバイスがONになっていて、 再生されている 量や音質が悪い ことを確認してください。 ・ 3.5mmミニプラグケーブルがAUX-INジャックに差し込まれ、 もう一方がデバイスの出力ジャックに差し込まれていること を、 確認してください。 ・ 機能ノブがAUXの位置であることを確認してください。 ・ 音量ノブが上がっているか確認してください。 ・ 音が出ない場合は、 AUXデバイスの音量を上げてください。 ・...

Table of Contents