bumpboxx Sound Stik MATCO Operation Manual

TWS PAiRiNG
INSTRUCTiONS
1. Power on both Bumpboxx Sound Stik devices. They will
automatically start in Bluetooth mode and make sure both
Bumpboxx Sound Stik devices have an open Bluetooth
connection (Please turn off Bluetooth on all previously
paired cell phones within range)
2. Hold the TWS (Pause/Play) button on your master unit
(the one closest to your device) for 5 seconds then
release. You will hear a chime within 10 seconds after
releasing. This means you have successfully established
your TWS connection.
(If this is unsuccessful, power down both devices, make sure all
previously paired cell phones and devices have turned off Bluetooth
and start again and use the slave Sound Stik as the master)
3. Just like you would normally do, find your Bumpboxx
Sound Stik on your Bluetooth list on your phone and pair to it.
4. Crank up the volume and enjoy.
BEST CARE
AND INSTRUCTIONS
• Once the unit is unpacked and has charged for
3-4 hours for the first time, you may power on and use.
• The unit may be used during the charging process.
VIEW OUR
HOW TO
VIDEOS
www.bumpboxx.com/howto
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE;
AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE
COULD VOID THE USER'S AUTHORITY TO OPERATE EQUIPMENT.
WARNING:
This product can expose you to chemicals including lead
and lead compounds, which are known to the state of
California to cause birth defects or other reproductive harm.
For more information go to www.p65warnings.ca.gov
OPERATION MANUAL