Table of Contents
Advertisement
3 Insert the loaded hard drive tray into the empty hard drive bay.
Important:
Make sure the tray is pushed in all the way. Otherwise, the hard disk might not be able to function
properly.
4 Press the handle in flush with the front panel to hold the hard drive tray in place.
5 Insert the hard drive tray key into the hard drive tray lock, turn the key clockwise to lock the handle of the hard
drive tray, and then remove the key.
6 Repeat the steps above to assemble all hard disks you have prepared.
7 Fix the two rack mount kits on both sides with the nuts provided.
8 The disks' positions are numbered as shown below.
Note:
If you want to set up a RAID set, it is recommended that all installed hard disks are of the same size to make
the best use of hard disk capacity.
7 Chapter 2: Hardware Setup
Advertisement
Table of Contents
