Preliminary Remarks; General Warnings - Immergas 3.030908 Instruction And Warning Book

Hereby Immergas S.p.A., declares that the radio equipment type "Concentrator kit with wireless room probe" is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available at the following Internet address: www.immergas.com.

PRELIMINARY REMARKS.

The "Concentrator Kit with wireless room probe" is composed of two devices capable of communicating with each other in radio frequency.
The radio associa-tion between the two devices is not pre-configured at the factory.
At the time of installation it is necessary to perform the operations listed below in order to activate the radio recognition and assign the
room control to the correct zone.
The wireless room probe will be placed in the room where you want to have temperature control. The wireless room probe runs on two
1.5V AA batteries and does not require wired electrical connection.
The concentrator must be connected to the boiler by cables (supplied with the kit) and must be placed near the boiler. If necessary, it can be
placed in rooms far from the boiler; in this case establish an adequate electrical connection (not supplied with the kit).
Both the probe and the concentrator are suitable for operation in dwelling; they cannot be used outdoors and / or subject to the weather.

GENERAL WARNINGS.

All Immergas products are protected with suitable transport packaging.
The material must be stored in a dry place protected from the weather.
This instruction manual provides technical information for installing the Immergas kit. As for the other issues related to kit installation (e.g.
safety in the workplace, environmental protection, accident prevention), it is necessary to comply with the provisions specified in the
regulations in force and with the principles of good practice.
Improper installation or assembly of the Immergas appliance and/or components, accessories, kits and devices can cause unexpected problems
for people, animals and objects. Read the instructions provided with the product carefully to ensure proper installation.
Installation and maintenance must be performed in compliance with the regula-tions in force, according to the manufacturer's instructions and
by professionally qualified staff, meaning staff with specific technical skills in the plant sector, as envisioned by the law.
This instruction leaflet has been prepared for: the Installer.
Carefully read the instruction in this document giving indications on the technical characteristics, installation, assembly and
•
association instructions.
The system must be compliant with applicable standards.
•
The instruction leaflet is to be considered part of the kit and must be "kept for future reference".
•
After removing the packaging, make sure all the components of the kit are intact and present. If in doubt, do not use them and
•
contact the Dealer or Manufacturer.
The kit is intended only for the use for which it was specially designed. Any other use must be considered improper and therefore
•
dangerous.
Our products are manufactured in compliance with the Safety Standards in force. It is, therefore, recommended to use all devices and
•
attention in such a way that injury/damage is not caused to persons or objects.
Do not disassemble parts of the kit when it is operating.
•
Do not use the kit exposed to heat sources or under the scorching sun.
•
Periodically check the battery charge of the wireless room probe.
•
Immergas reserves the right to make improvements and changes to details and accessories, excepting the essential features of the
•
model described and illustrated herein.
2
IE