Philips easyLINK 29PT8413 Manual page 11

SOUND
J Dolby Pro Logic
Dolby Pro Logic
Volume
Graphic Equalizer
Loudness
Headphone
Dolby Pro Logic
Left
Centre
Rear
J Start Test
Start Test
Stop Test
Centre Volume
Balance
Rear Volume
Surround Mode
Pro Logic
Dolby 3 Stereo
Hall
Off
Dolby* Pro Logic
Adjust the volume balance level of the loudspeakers
Most programmes will sound good with the volume balance between the
centre left and right and rear loudspeakers in an equally loud position.
However, some programmes may benefit from an adjustment of the level of
the respective speakers.
Which loudspeakers are active depends on the Surround Mode selection you
make below.
& Select Pro Logic in Surround Mode of the
Right
é Select Start Test and press the OK key.
A steady noise tone is switched sequentially through the left, centre, right and
rear loudspeakers, for 2 seconds each. This enables you to adjust the volume
of the separate loudspeakers.
Rear
The loudspeakers activated light up in the on screen graphic.
" Select Centre Volume, Balance or Rear Volume and alter the selected
adjustments.
' Select Stop Test in the
you have finished the adjustments of the level of the speakers.
Surround mode
Select the Dolby Surround Sound mode according to the sound mode being
broadcast.
Pro Logic (with Dolby Surround broadcasting)
In addition to the left and right front speakers, the centre and the rear
surround loudspeakers reproduce the Dolby Surround Pro Logic sounds.
This 4-channel sound is always recorded when the movie or programme is
marked with
This mode is especially recommended for such programmes as movies.
Dolby 3 Stereo (with Dolby Surround broadcasting)
The Dolby 3 Stereo sound signal is now distributed over the front left, the
front right and the centre loudspeakers.
The rear loudspeakers do not produce any signal.
Hall (with Dolby Surround broadcasting)
The centre sound signal is distributed over the rear loudspeakers which
creates a hall effect from the rear.
The centre loudspeaker does not produce any signal.
This mode is recommended when you wish to add surround sound to a
broadcast which is not encoded Dolby Surround.
Off
This mode reproduces only the left and right front sound signals.
You only hear a stereo sound if the broadcast which you are watching or
listening to is transmitted in stereo or digital sound.
•
Press the green
'Dolby' 'Pro Logic' and the double-D symbol
*
Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories Licensing Corporation.
DOLBY PRO LOGIC
Dolby Surround.
key to return to the
MENU
are trademarks of Dolby
menu.
DOLBY PRO LOGIC
menu and press the OK key when
menu.
SOUND
11