Troubleshooting - FUJIDENZO INR-82S User Instruction

Daily Use
Troubleshooting
Problem
Appliance doesnot
work
Possible cause
Mains plug is not plugged in
oris loose
Solution
Insert mains plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freozes or
cools too much
Temperature is set to COIDEST
setiing
Turn the temperature regulator to a
warmer setting temporarily.
The food is not frozen
enough.
Temperature is not properly
adjusted.
Please ook in the initial Temperature
Setting saction.
Door was open for an extended
period.
Qpen the door only as long as
necessary.
Alarge quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation to
a colder setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Heavy build up of
frost on the door
seal
Door seal is not air tight.
Carefully warm the leaking sections of
the door seal w i t h a hair dryer (on a cool
setting). At the same time shape the
warmed door seal by hand such that it
sits correctly.
Unusual noises
Appliance is notlevel.
Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
Acomponent, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend the
component out of the way.
Ifthe malfunction shows again, contact the Service Center.