PARTS & DESCRIPTION COOL SWING Control Panel Short Louvers Long Louvers Wheel Ice Pack (two) (for Water Tank) Cooling Pad Dust Filter Water Tank...
Page 3
WARNINGS ATTENTION : Read this booklet carefully as it contains important instructions for a safe installation, use and maintenance. Important instructions to be kept for future reference. The following basic precautions should always be followed when using electrical appliances: Read all instructions before using the appliance. This appliance must be used only for the purpose it was expressly designed;...
Page 4
If you are using the appliance for the first time, you should: Clean the exterior parts of the appliance with damp cloth moistened with warm water with a non-abrasive sponge. Take special care that the Control Panel found at the top of the appliance is kept dry. Check that the Fan Grills and Fan Blade are NOT damaged.
Page 5
DO NOT soak the appliance in water or other liquids, wash it under the tap, or let any liquid flow into the internal casing of the appliance to prevent electric shock. In case of accidental fall in water, DO NOT try to take it out, but first of all unplug immediately the power cable from the socket.
HOW TO USE Warning: The fan is fully assembled. DO NOT operate the fan with any of its parts disassembled. The entire assembled unit works as a single appliance. The fan must only operate in the upright position. Any other position will be hazardous. Avoid using the appliance in a closed environment.
Page 7
5. What the Functions Buttons do: Function Press the COOL Button on the Control Panel once to enter the COOL mode. COOL Press again to exit the COOL mode. Press the 0 (OFF) Button on the Control Panel once to turn the appliance OFF.
HOW TO CLEAN Press the 0 (OFF) Button on the Control Panel to switch off the fan. Unplug the power cable holding it firmly with dry hands. Wait for the appliance to cool down completely. Clean the exterior parts of the fan thoroughly with damp cloth moistened with warm water &...
Page 9
Remove the Back Shutter on the back of the appliance. The Back Dust Filter attached to the Back Shutter can be detached. Then remove the Back Cooling Pad. Cooling Pad Dust Filter Clean the Dust Filter, Cooling Pad and Shutter under running water. Let the components air-dry before replacing them in their respective positions on the appliance.
PROBLEM SOLVING Fault symptom Cause analysis Troubleshooting The appliance The power cable could be Please stop use and contact does not respond damaged. customer service. when any of the AC fuse could be damaged or Replace the fuse or restart the buttons are the circuit stops functioning to unit.
Page 11
The appliance The Cooling Pad is dry or Clean the Water Tank and functions, but the contain an insufficient amount replace the water in the Water air coming out is of water due to either Tank. Clean the Water Hose. not cool enough.
Page 12
White sediments The water in the Water Tank is As water is continually removed in the Water Tank. saturated with salt. from the Water Tank, various salts are left behind, which in time become saturated and exceed their Solubility Product values (Ksp).
Page 13
ENVIRONMENTAL TIP This device, along with all other electronic devices, should, when it is no longer capable of functioning, be disposed with the least possible environmental damage according to the local regulations in your area. In most cases you can discard the device at your local recycling center.
WARRANTY The manufacturer provides warranty in accordance with the legislation of the customer’s own country of residence, with a minimum of 1 year, starting from the date on which the appliance is sold to the end user. The warranty covers defects in material and workmanship. The repairs under warranty may only be carried out by an authorised service centre.
Need help?
Do you have a question about the ifan EVAPORATIVE IF7310 and is the answer not in the manual?
Questions and answers