Table of Contents
Advertisement
Quick Links
Gardner Denver Welch Vacuum Technology, Inc.
5621 W. Howard Street
Niles, IL 60714
Phone: (847) 676-8800
Fax: (847) 677-8606 (Technical Support)
E-Mail: gdwelchvacuum@gardnerdenver.com
Web-Page: www.welchvacuum.com
OWNER'S MANUAL
ASPIRATION / FILTRATION
VACUUM SYSTEM
Model 2515B-75
Not recommended for pumping acid,
base or organic vapors or gases.
FOR
MODELS:
2511 & 2515
Warning
For outside of U.S. and Canada, contact your local
Gardner Denver sales office, see back page
Model 2515C-75 & 2515C-76
Approval Agency's
Printed in USA
Part No. 642783
Advertisement
Table of Contents
Related Manuals for Gardner Denver WELCH 2511
Summary of Contents for Gardner Denver WELCH 2511
- Page 1 Gardner Denver Welch Vacuum Technology, Inc. For outside of U.S. and Canada, contact your local 5621 W. Howard Street Gardner Denver sales office, see back page Niles, IL 60714 Phone: (847) 676-8800 Fax: (847) 677-8606 (Technical Support) E-Mail: gdwelchvacuum@gardnerdenver.com...
- Page 2 INSTRUCTION WARNING AND CAUTION PLEASE READ BEFORE OPERATION While reading your manual, please pay close attention to areas labeled: WARNING AND CAUTION. The description of each is found below. WARNING Warnings are given where failure to observe instruction could result in injury or death to people.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Section 01 - SAFETY INFORMATION 1.10 Caution To Prevent Injury 1.20 Caution To Reduce Risk Of Electrical Shock 1.30 Warning To Reduce Risk Of Electrocution 1.40 Danger To Reduce Risk Of Explosion Or Fire Section 02 - INSTALLATION 2.10 Introduction 2.20... -
Page 4: Caution To Prevent Injury
SECTION 1: SAFETY INFORMATION 1.10 Caution: To Prevent Injury... 1.11 Never operate this product if it has a damaged cord or plug. If it is not working properly, has been dropped, damaged or has fallen into water, please return the product to a Welch service center for examination and repair. -
Page 5: Section 02 - Installation
SECTION 2: INSTALLATION 2.10 Introduction 2.11 This manual has been compiled not only for the care and maintenance of the Welch Aspiration/Filtration Vacuum System now in your possession, but as a helpful reference and guide to prevent many problems which may occur if used improperly. 2.20 Unpacking 2.21 Carefully remove the Aspiration/Filtration Vacuum System from the shipping case. -
Page 6: Intake And Discharge Provision
2.50 Intake And Discharge Provision 2.51 The vacuum regulator and vacuum dial gauge is attached to the collection jar. The vacuum regulator allows the vacuum level to be set between roughly atmospheric pressure and the maximum vacuum allowed for the pump model. The collection jar and hydrophobic filter keeps water from accidentally being drawn into the unit. -
Page 7: Electrical Power
2.60 Electrical Power 2.61 Power Source Review Review the power source and the motor rating to be sure they agree in voltage, phase, and frequency. Serious damage may occur to the motor if it is connected to an improper voltage. All Welch pumps must be grounded. -
Page 8: Section 03 - Operation
SECTION 3: OPERATION 3.10 Starting Procedures 3.11 Starting a Welch Aspiration/Filtration Vacuum System Before attaching the pump to a system, familiarize yourself with the function and action of the Aspiration/Filtration Vacuum System that you have acquired. Review the power requirements as described in Section 2.60. -
Page 9: Operating Pressure Range
3.30 Operating Pressure Range 3.31 Aspiration/Filtration Vacuum Systems are designed to be run from slightly below atmospheric to their maximum vacuum level on the intake side. Consult the Specification Table for the ratings of your specific model (See Section 6, Specifications). 3.40 Shutdown Procedures 3.41 After use, Welch recommends the pump be run for about 2 minutes disconnected from the vacuum... -
Page 10: Section 05 - Troubleshooting
SECTION 5: TROUBLESHOOTING 5.10 VACUUM PROBLEMS 5.11 Leakage, contamination, and unusual outgassing are the general causes of problems associated with poor vacuum. To operate at maximum efficiency, a system must be thoroughly clean. If the system is completely clean and free from leaks and unwarranted vacuum problems still exist, the pump should be checked. - Page 11 5.40 TROUBLE SHOOTING GUIDE FOR 2515 MODELS Symptoms Possible Cause Remedies Reduced/low 1. Clogged hydrophobic 1. Replace the filter vacuum filter. following directions in this manual. (Section 4.12) 2. Regulator improperly 2. Set regulator vacuum set. level following operating instructions. 3.
-
Page 12: Section 06 - Specification
SECTION 6: SPECIFICATION 6.10 SPECIFICATION TABLE Model 2515 Catalog No. 2515B-75 2515C-75 2515C-76 Free Air Displacement CFM (L/min) 1.2 (34) 1.0 (28) 1.2 (34) Maximum Vacuum 27.2 in. Hg Ultimate Vacuum 70 Torr (93 mbar) Dimensions L x W x H in. (cm) 14.8 x 8.3 x 10 Inches (37.5 x 21 x 25.5 cm) Shipping Weight 19 lbs... -
Page 13: Section 07 - Warranty
The method of executing this warranty: servicing, adjusting, repairing or replacing shall be at the discretion of Gardner Denver Welch Vacuum Technology . Vacuum pumps that have been used for any period, however short, will be repaired under this warranty rather than replaced. - Page 14 8.11 Model 2515B-75 / 2515C-75 / 2515C-76 COLLECTION LONG PUMP ON/OFF SWITCH TUBING APPLICATION HYDROPHOBIC SHORT REGULATOR VACUUM GAUGE TUBING FILTER TUBING KNOB...
- Page 15 8.12 Model 1475K-20 COLLECTION LONG TUBING SHORT TUBING HYDROPHOBIC FILTER APPLICATION TUBING...
- Page 16 SECTION 9: KITS AND ACCESSORIES 9.10 REPAIR KITS 9.11 Repair Kit for Model 2515 Service Seal Gasket Description 2515K-01 2515K-02 Connecting Rod Assembly #1 Handle Screw #2 Head Screw #3 Head O-Ring #4 Valve Plate Assembly #5 Cylinder O-Ring #6...
- Page 17 9.20 VACUUM ACCESSORIES 9.21 Table for Vacuum Accessories Description Welch Kit Adapter S.S. 40mm 1475K-01 8-Channel Adapter S.S. 40mm 1475K-02 1-Channel Adapter for dispoable tips, w/o ejector 1475K-03 Rubber Adapter for Pasteur pipettes 1475K-04 8-Channel Adapter for dispoable tips, w/ejector 1475K-05 Adapter S.S.
- Page 18 9.30 ELECTRICAL ACCESSORIES 9.31 Table for Electrical Accessories Description Welch Kit 115V 60Hz - Maintained on/off footswitch 1430A 115V 60Hz - Variable on/off footswitch 1430B 90-230V 50/60Hz - Variable on/off footswitch with IEC connections 1430C 9.40 REPLACEMENT ACCESSORIES 9.41 Table for Replacement Accessories Description Welch Kit Aspiration Kit - Includes: 6 ft tubing, 2000ml Autoclavable...
- Page 20 Thank you for reading this data sheet. For pricing or for further information, please contact us at our UK Office, using the details below. UK Office Keison Products, P.O. Box 2124, Chelmsford, Essex, CM1 3UP, England. Tel: +44 (0)330 088 0560 Fax: +44 (0)1245 808399 Email: sales@keison.co.uk...
Need help?
Do you have a question about the WELCH 2511 and is the answer not in the manual?
Questions and answers