Installing The Drain Hose - LG F2T2TYM1S Owner's Manual

global_main.book.book Page 15 Tuesday, October 11, 2022 10:05 AM
Connecting One Touch Type Hose to Tap
Without Thread
1
Unscrew the adapter ring plate
the 4 fixing screws.
2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
and loose
d
if the tap is too large
e
down, push
f
INSTALLATION
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Connecting the Hose to the
Appliance
Screw the supply hose to the water inlet valve on
the back of the appliance.
• Do not connect the hose to the hot water supply
for models with one water inlet. Connect to the
cold water supply only.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. In
case that the tap is square or too big, remove the
guide plate before inserting the tap into the
adaptor.
• Make sure that the hose should not be kinked or
trapped.

Installing the Drain Hose

Installing the Drain Hose with
the Elbow Bracket
The drain hose should not be placed higher than
100 cm above the floor. Water in the appliance may
not drain or may drain slowly.
15