Table of Contents
Advertisement
Before you start
Installation
Install the product according to the instructions in this manual and local codes.
Installing the product
1. Select a solid, level location with adequate space for the following clearances.
Top
Sides
Rear
-
If the minimum clearances are not met, performance will decrease due poor ventilation and
condensation may occur on the product exterior.
-
Do not install the product in direct sunlight or hot and cold places. The ambient temperature must be
between 10 °C - 35 °C. If the ambient temperature is too high or too low, the product may not operate
normally, or performance may decrease.
A
B
10
English
Untitled-1 10
25 mm
14 mm
15 mm
2. Turn the levelling feet (A) clockwise or
counterclockwise to adjust the height until the
product is level.
NOTE
If the product wobbles or if you want to raise the
height of the rear side, assemble the provided rear
levelling feet (B) on the bottom-rear sides of the
product.
2021-06-16
3:31:03
Advertisement
Table of Contents
