DELTA GROUP VIVOTEK AM-71G Quick Start Manual

VIVOTEK Mounting Accessories
AM-71G Junction Box
Installation Guide
Revison History:
Rev. 1.0: Initial release
I Compatible VIVOTEK Cameras
Compatible cameras/brackets
FFD9167-HT-v2, FD9367-EHTV-v2, FD9365-EHTV-v2, FD9391-EHTV-v2, IB9367-EHT-v2, IB9367-EHT-v2 (5-50MM), IB9365-
EHTV-v2, IB9391-EHTV-v2
Compatible accessory models: AM-312, AM-412, AM-522
Mounting Dimensions
51.00 51.00
5
Pass cables through the center hole on the top cover. Secure the
top cover by driving screws.
5 ~ 8mm
Connect cables to the Ethernet port and terminal block.
Note that the silicon waterproof seals should also
be properly installed on the camera. Insert the cables
through the waterproof seals.
Part no.: 5019034100
Accessory Ordering part no.: VIO100000003
Package Contents
x4 x4
6
Remove the dome cover and waterproof connectors.
Installation
II
Remove the top cover and unhook the tether wire.
NOTE: If you have a POE extender or EPoC device, install them now.
Refer to the later section for details.
1
3
Remove the plastic cover and seal ring from the conduit hole you
want to use, and install them the conduit hole you don't want to use
to make sure the bracket is waterproof.
x4
7
Install the cable gland and pass cables through it.
9 Secure the camera top cover.
Connect a ground wire to this position.
2
Attach the included alignment sticker to a preferred position. Drill
holes on the wall and install the junction box. If space behind the
wall allows, you may also pass cables through the wall.
4
A 3/4" conduit is required for routing the cables with waterproof
connection.
13kgf.cm
8
Pass cables through the routing holes and install the camera to box by
driving screws.
10
Open a live view console and adjust the shooting direction. Refer to the
camera's QIG for more information.