Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Host HOST0902PM
- Page 1 Planetary Mixer Instruction manual Model: HOST0902PM HOST0903PM HOST0904PM Read this instruction manual carefully before use HOST0902PM_HOST0903PM_HOST0904PM_EN_A5_v1_20220817.indb 1 HOST0902PM_HOST0903PM_HOST0904PM_EN_A5_v1_20220817.indb 1 2022/8/17 17:36:08 2022/8/17 17:36:08...
-
Page 2: Safety Instructions
Safety Instructions THE PLANETARY MIXER IS A DANGEROUS APPLIANCE AND MUST ONLY BE USED BY TRAINED PERSONNEL IN ACCORDANCE WITH THESE INSTRUCTIONS . • Position on a flat, stable surface. • A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product. - Page 3 RCD (Residual Current Device). Introduction The HOST Planetary Mixer has been designed to mix a range of foodstuffs, varying from cream to dough. Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your HOST product.
-
Page 4: Installation
WARNING: The bowl must be attached and raised into position prior to starting the Planetary Mixer. • HOST accept no responsibility for any injury caused by incorrect assembly of this appliance. Note: Ensure the feet are level to reduce vibration during operation. •... - Page 5 Fitting/Removing the Bowl 1. Turn Off the appliance. 2. Open the safety guard by turning it to the left (HOST0902PM & HOST0903PM) or lifting it above the mixer (HOST0904PM). 3. Lower the bowl with the bowl handle. 4. Release the locking catches either side of the bowl.
- Page 6 Changing the Mixer Attachment 1. Turn Off the appliance. 2. Open the safety guard by turning it to the left (HOST0902PM & HOST0903PM) or lifting it above the mixer (HOST0904PM). 3. Lower the bowl with the bowl handle. 4. Push the mixer attachment up and to the left to release it.
-
Page 7: Operation
2. Fill the bowl. 3. Select the desired speed and close the guard. • Note: HOST recommend that you start with the slowest speed and increase the speed gradually as necessary. • Ensure the safety guard is fully closed or the mixer will not work. -
Page 8: Cleaning, Care And Maintenance
Overload Switch The Overload switch is situated at the back of the machine beside the cable entry (Note for HOST0902PM: The Overload switch is on the base). If the appliance becomes too hot the Overload switch will stop the machine automatically. If this happens:... -
Page 9: Technical Specifications
Cannot select gear Gearing cogs misaligned Turn Off appliance and manually turn the whisk attachment slightly. Select the gear again Service Should your appliance have a fault, please visit the Service section of the HOST website. Technical Specifications Dimensions Weight... - Page 10 All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HOST. Every effort is made to ensure all details are correct at the time of going to press, however, HOST reserve the right to change specifications without notice.
- Page 11 DocuSign Envelope ID: DA4256D2-A1DE-4750-BC23-AF75CB542431 UKCA Declaration of Conformity {Host} {Host House, Chepstow, NP16 6UP} hereby declare that the equipment is in conformity with the requirements of the following Regulations: Supply of Machinery (Safety) Regulations 2008 Electromagnetic Compatibility Regulations 2016 ...
- Page 12 HOST0902PM_HOST0903PM_HOST0904PM_EN_A5_v1_2022/08/17 HOST0902PM_HOST0903PM_HOST0904PM_EN_A5_v1_20220817.indb 12 HOST0902PM_HOST0903PM_HOST0904PM_EN_A5_v1_20220817.indb 12 2022/8/17 17:36:10 2022/8/17 17:36:10...
Need help?
Do you have a question about the HOST0902PM and is the answer not in the manual?
Questions and answers