TABLE OF CONTENTS ASSEMBLY TIPS & WARNINGS PARTS IDENTIFIER ASSEMBLY INSTRUCTIONS BACKREST ASSEMBLY INSTRUCTIONS OPERATION INSTRUCTIONS ENJOYING YOUR SAUNA HEALTH & SAFETY WARNINGS CLEANING & MAINTANENCE 14-15 TROUBLESHOOTING GUIDE SAUNA USE DISCLAIMER REPLACEMENT PARTS 16-18 WARRANTY INFORMATION If you would like a French version of this manual, please contact our Customer Service Department at 800-759-0977 or custserv@splashnetxpress.com Si vous voulez une version française d’un manuel, s'il vous plaît contacter notre service à...
ASSEMBLY TIPS & WARNINGS • Before you begin, read all assembly instructions and safety warnings carefully. • This sauna requires at least 2 adults to complete assembly. • Remove all of the contents from boxes and verify that you have all of the parts shown on the Parts Note: Some parts may be pre-installed or pre-assembled.
PARTS IDENTIFIER (NOT TO SCALE) This manual is used for the assembly of several sauna models; therefore, some images or drawings may not look exactly like your product. The parts identi ed above, unless otherwise indicated, are the main components used for assembly. Other pre-assembled parts are listed on PAGE 15 and 16.
ASSEMBLY INSTRUCTIONS 1. Begin assembly by determining an appropriate location for your sauna – see ASSEMBLY TIPS & WARNINGS for details. Place the FLOOR PANEL on the oor in this location. 2. Place the BACK PANEL on the FLOOR PANEL, lining up the BACK PANEL against the oor trim piece on the backside of the FLOOR.
Page 6
ASSEMBLY INSTRUCTIONS (CONT.) 4. Place the LEFT PANEL on the FLOOR in the same manner and buckle it to the BACK PANEL. 5. Slide the BENCH SUPPORT HEATER PANEL (LONG) into place between the two SIDE PANELS Connect the heater plug. Note: It may be necessary to move a side wall out slightly to do this. 6.
Page 7
ASSEMBLY INSTRUCTIONS (CONT.) 7. Attach two FRONT SIDE BENCH SUPPORTS to BENCH SUPPORT HEATER PANELS (SHORT) with 2” SCREWS. Attach each BENCH SEAT with 2” SCREWS. 8. Place the FRONT PANEL on front lip of the FLOOR and buckle it to the SIDE PANELS. Lift the ROOF above the sauna, feeding the control panel and heater cables through the corresponding holes.
Page 8
ASSEMBLY INSTRUCTIONS (CONT.) 10. Feed the main power cable through hole in ROOF and plug securely into receptacle on back of POWER SUPPLY box . Secure the ROOF COVER with 3/4” SCREWS. 11. Connect touch screen control panel as shown and mount frame to BACK PANEL with 2” SCREWS. NOTE: Please see info on Page 11 about USB cable usage.
Page 9
ASSEMBLY INSTRUCTIONS (CONT.) 13. Remove the back cover of the OXYGEN IONIZER by turning it as indicated. Unwrap and install the fragrance patch, then reattach the back cover. Attach the OXYGEN IONIZER in the designated position with 3/4” SCREWS. Plug the power cable into the OXYGEN IONIZER. 14.
SA1315/SA1322 BACKREST - SAP2818 Assembly Instructions / Instructions d’assemblage Images Not to Scale / llustrations non à l'échelle SAP2818 SAP2818 SAP2818 SAP7019* SAP7019* Backrest Side Support Brace 2” (50mm) Screw 1-1/8” (30mm) Screw Dossier Support latéral Entretoise Vis de 2 po (50 mm)
OPERATION INSTRUCTIONS SAUNA CONTROL PANEL - 3. Set °C or °F 7. Lights (Inside & Outside) MAIN SCREEN 1. & 6. Power Home Screen 5. Temperature & Return to Last Screen Time Readings Volume NOTE: Please see info below on 2.
ENJOYING YOUR SAUNA 1. Prior to initial use, wipe down all interior surfaces of the sauna with a damp cloth. 3. Always drink plenty of water before, during and after your sauna session to stay properly hydrated. 4. A normal sauna session should last 30 minutes or less. 5.
HEALTH & SAFETY WARNINGS 1. Review all instructions and warnings before operating your sauna. A sauna is not a toy. Seri- ous injury may result from negligence, intentional misuse and failure to follow safety instruc- tions. 2. Hyperthermia Danger: Hyperthermia occurs when the body absorbs more heat than it can emergency and requires immediate treatment to prevent disability or death.
CLEANING & MAINTENANCE 1. Always unplug the sauna and allow it to cool down before performing any cleaning or maintenance. 2. Use furniture polish or furniture oil when cleaning the sauna exterior. 3. The sauna interior surfaces should only be wiped down with a damp cloth. Do NOT use 4.
TROUBLESHOOTING GUIDE (CONT.) Problem THE CONTROL PANEL DOES NOT WORK 1. Check that all the connections are tight. 2. If the numbers are scrambled or the buttons are unresponsive, Solution replace the Control Panel. 3. If the temperature indicator does not work or reads “--” or “EP”, replace the Control Panel.
REPLACEMENT PARTS Rev. 1/19 SA1315 3 to 4-PERSON CEDAR ELITE SAUNA WITH CARBON HEATERS REF. # DESCRIPTION PART NUMBER QTY. FRONT PANEL with GLASS DOOR SAP2800 BACK PANEL SAP2801 LEFT PANEL SAP2802 RIGHT PANEL SAP2803 BENCH SEAT (LONG) SAP2804 ROOF...
Page 17
REPLACEMENT PARTS Rev. 1/19 SA1322 4 to 5-PERSON CEDAR ELITE SAUNA WITH CARBON HEATERS REF. # DESCRIPTION PART NUMBER QTY. FRONT PANEL with GLASS DOOR SAP2830 BACK PANEL SAP2831 LEFT PANEL SAP2832 RIGHT PANEL SAP2833 BENCH SEAT (LONG) SAP2834 ROOF SAP2835 FLOOR SAP2836...
Page 18
PARTS SCHEMATIC Rev. 9/18 SA1315 & SA1322 This drawing is for illustrative purposes only. It will not match your sauna exactly, but will indicate location of similar parts. Illustrations are not to scale. 34,35...
SAUNA WARRANTY REGISTRATION CARD 1. This sauna has a 7-Year Limited Warranty against defects in materials and workmanship from date of purchase. To receive the warranty, the card below must the wood structure*. Heating elements and all electronics are covered by a 5-Year Limited Warranty. The radio/CD player (if included with your sauna) is covered by a limited 1-Year Warranty.
Need help?
Do you have a question about the SA1315 and is the answer not in the manual?
Questions and answers